Preliminary Investigation of Micro-V-Bending
نویسندگان
چکیده
منابع مشابه
investigation of the electronic properties of carbon and iii-v nanotubes
boron nitride semiconducting zigzag swcnt, $b_{cb}$$n_{cn}$$c_{1-cb-cn}$, as a potential candidate for making nanoelectronic devices was examined. in contrast to the previous dft calculations, wherein just one boron and nitrogen doping configuration have been considered, here for the average over all possible configurations, density of states (dos) was calculated in terms of boron and nitrogen ...
15 صفحه اولMicro-Raman Measurement of Bending Stresses in Micromachined Silicon Flexures
Micron-scale characterization of mechanical stresses is essential for the successful design and operation of many micromachined devices. Here we report the use of Raman spectroscopy to measure the bending stresses in deep reactive-ion etched silicon flexures with a stress resolution of 10 MPa and spatial resolution of 1 m. The accuracy of the technique, as assessed by comparison to analytical a...
متن کاملOn the Bending of Electromagnetic Micro-Waves Below the Horizon.
that c is changed to ic in the functions Se. 1 Stratton, Proc. Nat. Acad. Sci., 1, 51-56 (1935). 2The functions Sel i/,m(c, cos u) are of course proportional to the Mathieu functions cem(u), and the So's to the functions sem(u). Whittaker and Watson, Modern Analysis, page 396. Watson, Theory of Bessel Functions, page 180. Whittaker and Watson, Modern Analysis, page 398. ' Relations can also be ...
متن کاملLaser Micro Bending Process of Ti6Al4V Square Bar
Laser micro bending process of Ti6Al4V square bar are carried out using a 3D thermo-mechanical finite element analytical model (FEM). The transient temperature fields, displacement fields, stress fields and strain fields are obtained and analyzed. The results show that the bending angel during laser micro bending process is in good agreement with experimental measurements. The effects of proces...
متن کاملAnalytical and Numerical Investigation of Four-roll Bending
Four-roll bending process is usually used for manufacturing of seamed thick-walled and thin-walled cylinders. Due to complexity of this process, the analytical solution of plate bending in this process has not been developed completely. The existence of friction and multi-step processing makes it more difficult. Investigation of four-roll bending process using analytical and numerical methods i...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: MATEC Web of Conferences
سال: 2017
ISSN: 2261-236X
DOI: 10.1051/matecconf/201710806001