PREPARATION AND CHARACTERIZATION OF Ce0.8Y0.2O2 NANOPOWDERS USING SOL-GEL METHOD
نویسندگان
چکیده
منابع مشابه
Synthesis, characterization, of Fluorohydroxyapatite nanopowders by sol-gel processing
In this work, sol-gel processing was used to synthesize the fluorohydroxyapatite (nano-FHA, Ca10(PO4)6(OH)2−xFx) nanopowders. The advantages of the sol-gel method over other methods are precise control of composition, low processing temperature, and better homogeneity. Calcium nitrate tetrahydrate, phosphorous pentoxide and Tetrabuthylammon...
متن کاملSynthesis, characterization, of Fluorohydroxyapatite nanopowders by sol-gel processing
In this work, sol-gel processing was used to synthesize the fluorohydroxyapatite (nano-FHA, Ca10(PO4)6(OH)2−xFx) nanopowders. The advantages of the sol-gel method over other methods are precise control of composition, low processing temperature, and better homogeneity. Calcium nitrate tetrahydrate, phosphorous pentoxide and Tetrabuthylammon...
متن کاملCharacterization of Rod-like High-purity Fluorapatite Nanopowders Obtained by Sol-gel Method
high purity fluorapatite (FA) with rod-like and spherical-like morphology was synthesized via sol-gel method. Chemical characterization of FA powders was done by XRD and FTIR analyses. Crystallite samples were calculated using Scherer method. Morphology of FA powders was investigated with TEM and SEM images. The results revealed that increasing the time of hydrolysis of phosphate sols significa...
متن کاملPREPARATION AND CHARACTERIZATION OF TiO2 Fe2O3 NANOCOMPOSITE BY SOL GEL METHOD
Nanocomposites have improved aspect ratio and better mechanical properties when compared to the composites which had structures less than 100nm They are 1000 times tougher compared to conventional composites. Besides mechanical properties, nanocomposites also have improved electrical conductivity, thermal stability, chemically resistant, flame retardant and low permeability. TiO2 finds its best...
متن کاملPreparation and Characterization of High Specific Surface Area γ-Alumina Nanoparticles Via Sol-Gel Method
In the present investigation, γ-alumina nanoparticles with particle sizes less than 10 nm, high specific surface area (351 m2/g), high pore volumes and relatively narrow pore sizes distribution was prepared via sol-gel method in presence of aluminum isopropoxide as an aluminum precursor, distilled water, acetic acid as hydrolysis rate controller and tert-butanol as solvent. They had meso ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: International Journal of Modern Physics: Conference Series
سال: 2013
ISSN: 2010-1945,2010-1945
DOI: 10.1142/s2010194513010635