Preparation and Characterization of Mullite Fiber Reinforced Alumina Matrix.
نویسندگان
چکیده
منابع مشابه
Mullite-alumina functionally gradient ceramics
Cracks free mullite-alumina Functionally Gradient Ceramics (FGC) have been obtained by sequential slip casting of Mullite-alumina slurries with diserent mullite/alumina ratios. These slurries were prepared with 65 % solids content and viscosities rangingpom 10 to 40 mPa.s. 7he presence of cracks perpendicular to the FGC layers have been attributed to residual stresses developed because of the m...
متن کاملstudy and characterization of fiber optical gyroscope مطالعه و مشخصه یابی ژیروسکوپ فیبر نوری(تار نوری)
ژیروسکوپ فیبر نوری fog بر اساس پدیده تداخل ساگنام دو پرتو لیزری از یک فیبر نوری بسیار طولانی داده های لازم را فراهم می آورد
15 صفحه اولSol-gel synthesis and characterization of alumina-15%mullite composite nanopowder
Homogeneous distribution of mullite in the matrix of alumina can be obtained through sol-gel method. In this work, nanopowder of alumina-mullite composite was synthesized with high homogeneity and high purity. So aluminum chloride hexahydrate and tetraethyl orthosilicate were used instead of alumina or mullite nanopowder. Studying the simultaneouse thermal analysis (STA) of mullite precursor re...
متن کاملPreparation and characterization of highly thulium- and alumina-doped optical fibers for single-frequency fiber lasers
Thulium-doped fibers suitable for core-pumped single-frequency lasers were fabricated by the modified chemical vapor deposition (MCVD) method. Refractive index profile, doping profile and spectral absorption was measured. High doping concentration of thulium ions should be achieved to allow for high absorption of light at a pump wavelength while the thulium ions clustering should be avoided to ...
متن کاملMullite/Alumina Mixtures for Use as Porous Matrices in Oxide Fiber Composites
Weakly bonded particle mixtures of mullite and alumina are assessed as candidate matrixes for use in porous matrix ceramic composites. Conditions for the deflection of a matrix crack at a fiber-matrix interface are used to identify the combinations of modulus and toughness of the fibers and the matrix for which damage-tolerant behavior is expected to occur in the composite. Accordingly, the pre...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: The International Conference on Applied Mechanics and Mechanical Engineering
سال: 2010
ISSN: 2636-4360
DOI: 10.21608/amme.2010.38234