Preparation of Cu/Ni Toughened B4C Matrix Composite Materials
نویسندگان
چکیده
منابع مشابه
Preparation, Properties, and Cell Attachment/ Growth Behavior of Chitosan/Acellular Derm Matrix Composite Materials
Composite membranes and sponge scaffolds consisting chitosan (CS) and acellular derm matrix (ADM) in six ratios were prepared by solvent evaporation technique and freeze-drying method, respectively. The composite materials were characterized by water contact angle measurement, scanning electron microscopy (SEM), water absorption and HaCat cells compatibility. The SEM result showed that CS/ADM t...
متن کاملMicrostructure and Dry-Sliding Wear Behavior of B4C Ceramic Particulate Reinforced Al 5083 Matrix Composite
B4C ceramic particulate–reinforced Al 5083 matrix composite with various B4C content was fabricated successfully via hot-press sintering under Argon atmosphere. B4C particles presented relative high wettability, bonding strength and symmetrical distribution in the Al 5083 matrix. The hardness value, friction coefficient and wear resistance of the composite were higher than those of the Al 5083 ...
متن کاملData on a Laves phase intermetallic matrix composite in situ toughened by ductile precipitates
The data presented in this article are related to the research article entitled "Laves phase intermetallic matrix composite in situ toughened by ductile precipitates" (Knowles et al.) [1]. The composite comprised a Fe2(Mo, Ti) matrix with bcc (Mo, Ti) precipitated laths produced in situ by an aging heat treatment, which was shown to confer a toughening effect (Knowles et al.) [1]. Here, details...
متن کاملPreparation, Microanalysis and Performance of Hap/Cs- Cmc Composite Materials
The physical and chemical properties of the materials are generally determined by their microstructure and main components. In this paper, the Hap/Cs-Cmc composite materials with different mass ratios were prepared for the first time through liquid co-precipitation method. The microstructure, phase and performance of the composite materials were investigated by FT-IR, XRD, TG-DTA, SEM, and EDS ...
متن کاملPreparation and Characterization of Composite Phase Change Materials Containing Nanoparticles
The phase change thermal control method is now widely used in aircraft thermal protection due to its high energy density, constant temperature control, flexible operation, and many other advantages.1–6 However, thermal conductivity of most current phase change materials is low in phase transition process.7–10 This paper will add high thermal nanoparticles to phase change material in order to en...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Material Sciences
سال: 2012
ISSN: 2160-7613,2160-7621
DOI: 10.12677/ms.2012.21004