Preparation of FeSi2 Thermoelectric Generator by HIP.
نویسندگان
چکیده
منابع مشابه
A MEMS Thermoelectric Generator by Samuel
The demand for portable power is large and expanding. Technologies currently available to meet this demand include batteries, fuel cells, thermophotovoltaic (TPV) generators and thermoelectric (TE) generators. Fuel cells and generators offer significantly improved performance over batteries, but issues of fuel processing and miniaturization remain. Microfabrication has the potential to address ...
متن کاملMultiphysics Simulations of a Thermoelectric Generator
Transient multiphysics simulations are performed to investigate the thermal and electric performance of a thermoelectric generator (TEG) module placed between hot and cold blocks. Effects of heat radiation, thermal and electric contact on the TEG are examined and the simulated results are compared with experimental data. The predicted temperature difference across the TEG module and the electri...
متن کاملDevelopmemnt of Flexible Thermoelectric Generator Using Fpcb
We proposed the flexible thermoelectric generator (TEG) using double side FPCB (flexible printed circuit boards). The proposed flexible thermoelectric generator has the unique vertical structure. The heat of the flexible thermoelectric generator flows vertically via plated through hole (PTH). The n-type (Bi-Te) and p-type (Sb-Te) thin films are deposited by the co-evaporator and patterned using...
متن کاملDesign of Cascaded Oxide Thermoelectric Generator
This paper describes the design of twoand three-stage cascaded oxide thermoelectric generators (TEGs) for high-temperature heat recovery using reported data to optimize energy conversion efficiency. We used the general intermetallic compounds Bi2(Se,Te)3 and (Bi,Sb)2Te3 for the low-temperature stages and oxides of TiO1:1, La-doped SrTiO3, NaxCo2O4, and Al-doped ZnO for the higher-temperature st...
متن کاملThe Effect of Aperture Size on the Cavity Performance of Solar Thermoelectric Generator
In this manuscript, a solar cavity packed with thermoelectric generator modules is investigated numerically. The hot plate of TEG modules make the inner surface of the cube, and the cold plate is outside of the cavity, under natural convection. The TEG modules are electrically in series. The solution algorithm using the equations of heat transfer and generated power of TEG modules is d...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Society of Powder and Powder Metallurgy
سال: 1992
ISSN: 0532-8799,1880-9014
DOI: 10.2497/jjspm.39.870