Preparation of magnetic oxide films by sputtering method.
نویسندگان
چکیده
منابع مشابه
Preparation of Light-Emitting Ytterbium-Doped Tantalum-Oxide Thin Films Using a Simple Co-Sputtering Method
Light-emitting ytterbium-doped tantalum-oxide thin films were prepared using a simple co-sputtering method for the first time. Sharp photoluminescence peaks having a wavelength of around 980 nm were observed from films annealed from 700 ̊C to 1000 ̊C for 10 to 40 min. The strongest intensity of the 980-nm peak was obtained from a film deposited using three ytterbium-oxide pellets and annealed at ...
متن کاملDEPOSITION OF THIN TiO2 FILMS BY DC MAGNETRON SPUTTERING METHOD
Sputter deposition process is another old technique being used in modern semiconductor industries. Sputtering is a process that can deposit TiO2 material on wafer/glass substrates. In this process target is connected to negative high voltage. Further argon gas is introduced into the chamber and is ionized to a positive charge. The positively charged argon atoms are attracted and strike the nega...
متن کاملSynthesis and Preparation of Oxide Ultrathin Films
There is a steadily growing interest in the research on oxide surfaces and films, due to their challenging fundamental properties and to their actual and potential applications in catalytic systems, chemical sensors, electronic and magnetic devices, and functional and aesthetic coatings. Special efforts have been directed at the study of ultrathin oxide films [1–11]. Such two-dimensional system...
متن کاملPreparation of delafossite CuFeO2 thin films by rf- sputtering on conventional glass substrate
CuFeO2 is a delafossite-type compound and is a well known p-type semiconductor. The growth of delafossite CuFeO2 thin films on conventional glass substrate by radio-frequency sputtering is reported. The deposition, performed at room temperature leads to an amorphous phase with extremely low roughness and high density. The films consisted of a well crystallized delafossite CuFeO2 after heat trea...
متن کاملPreparation of Bismuth Titanate Films by Electron Cyclotron Resonance Plasma Sputtering-Chemical Vapor Deposition
Bismuth titanate (Bi,Ti,O,, :BIT) thin films were prepared on the Pt courted MgO(100) substrate by electron cyclotron resonance plasma sputtering-chemical vapor deposition (ECR plasma sputtering-CVD). Bi20, was used as a sputtering target and tetra-isopropoxy-titanium [Ti(i-C3H70)4] as a CVD source. The composition of films was controlled by changing RF power (P,,) of Bi,O, target and Ti source...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Magnetics Society of Japan
سال: 1985
ISSN: 0285-0192
DOI: 10.3379/jmsjmag.9.121