Preparing Ultra-Smooth SEM Stud Surfaces
نویسندگان
چکیده
منابع مشابه
Preparing porcelain surfaces for optimal bonding.
When placing an indirect restoration such as a porcelain veneer, inlay, or onlay, the intaglio surface is typically treated in some fashion to ensure optimal bonding to the resin-based adhesives and luting cements required to affix it to the tooth tissues. A variety of surface preparation techniques have been advocated, including the use of acids, particle abrasion, various adhesives, and chemi...
متن کاملUltra - smooth platinum surfaces for nanoscale devices fabricated using chemical mechanical polishing
A technique involving two steps of chemical mechanical polishing (CMP) has been developed to produce ultra-smooth metal surfaces with an RMS roughness better than 0.1 nm. A figure of merit termed degree of smoothness (DOS) is proposed for the purpose of quantifying the extent of smoothness of a polished metal surface. A post CMP metal slurry cleaning solution was used for cleaning Pt slurry for...
متن کاملUltra-smooth metal surfaces generated by pressure-induced surface deformation of thin metal films
We present a mechanical pressing technique for generating ultra-smooth surfaces on thin metal films by flattening the bumps, asperities, rough grains and spikes of a freshly vacuum deposited metal film. The method was implemented by varying the applied pressure from 100 MPa to 600 MPa on an e-beam evaporated silver film of thickness 1000 Å deposited on double-polished (100)-oriented silicon sur...
متن کاملProbing liquid surfaces under vacuum using SEM and ToF-SIMS.
We report a newly developed self-contained interface for high-vapor pressure liquid surfaces to vacuum-based analytical instruments. It requires no wires or tubing connections to the outside of the instrument and uses a microfluidic channel with a 3 μm diameter window into the flowing fluid beneath it. This window supports the liquid against the vacuum by the liquid's surface tension and limits...
متن کاملCombining confocal and BSE SEM imaging for bone block surfaces.
The present report presents a method for the correlation of qualitative and quantitative BSE SEM imaging with confocal scanning light microscopy (CSLM) imaging modes applied to bone samples embedded in PMMA. The SEM has a proper digital scan generator: we leave the BSE image unchanged, and match the CSLM image to it, because the CSLM scan mechanism is not digital, though the signal is digitised...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Microscopy Today
سال: 2002
ISSN: 1551-9295,2150-3583
DOI: 10.1017/s1551929500058521