Pressure Butt Welding of Steel Pipes Using High Frequency Induction Heating (Report 1)

نویسندگان
چکیده

برای دانلود رایگان متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Some Studies on Temperature Distribution Modeling of Laser Butt Welding of AISI 304 Stainless Steel Sheets

In this research work, investigations are carried out on Continuous Wave (CW) Nd:YAG laser welding system after preliminary experimentation to understand the influencing parameters associated with laser welding of AISI 304. The experimental procedure involves a series of laser welding trials on AISI 304 stainless steel sheets with various combinations of process parameters like beam power, beam...

متن کامل

Quality Monitoring at Fusion Welding of Polyethylene High-density Pipes

D. Šoštarić, A. Pintarić, Faculty of Electrical Engineering, J. J. Strossmayer University of Osijek, Osijek, Croatia. I. Samardžić, Mechanical Engineering Faculty, J. J. Strossmayer University of Osijek, Slavonski Brod, Croatia. The paper presents the main parameters of fusion welding and their Off line analysis of Polyethylene high-density (PE-HD) pipes. By direct measurements of voltage and c...

متن کامل

Frequency Selectable Induction Heating Targets

This paper examines a scheme for developing frequency selectable induction heating targets for stimulating temperature sensitive polymer actuators. “Frequency selectable” implies that each target has a frequency at which it heats preferentially compared to other remaining targets. Single-turn conductors whose critical dimensions are small compared to their associated skin depth (over the freque...

متن کامل

Study on electron beam butt welding of austenitic stainless steel 304 plates and its input–output modelling using neural networks

Butt welding of austenitic stainless steel 304 plates was carried out using an electron beam. Experiments were conducted for various combinations of input process parameters determined according to central composite design. Three input parameters, namely accelerating voltage, beam current, and welding speed were considered during the experiments. The weld-bead parameters, namely bead width and ...

متن کامل

CFD Modelling of Friction Stir Welding of Aluminum to Steel butt joint

In this article effects of friction stir welding (FSW) tool rotational and traverse speeds were studied on heat generation and temperature distribution in welding zone of AA1100 aluminum alloy and A441 AISI joint. Computational fluid dynamics method was used to simulate the process with commercial CFD Fluent 6.4 package. To enhance the accuracy of simulation in this Study, the welding line that...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Journal of the Japan Welding Society

سال: 1972

ISSN: 0021-4787,1883-7204

DOI: 10.2207/qjjws1943.41.1197