Pressureless sintering behavior of injection molded alumina ceramics
نویسندگان
چکیده
منابع مشابه
Comparison of Creep Behavior in Alumina Based Ceramics Densified by Spark Plasma Sintering and Hot Pressing
Spark plasma sintering (SPS) method, as plasma activated sintering, is a method applicable for rapid sintering of metals and ceramics. Owing to the advantage of rapid heating, the alumina ceramics obtained by SPS have a grain size and density comparable to those of hot pressed ones. The increase of densification rate may be related to some difference in ion transport characteristics. This study...
متن کاملcomparison of creep behavior in alumina based ceramics densified by spark plasma sintering and hot pressing
spark plasma sintering (sps) method, as plasma activated sintering, is a method applicable for rapid sintering of metals and ceramics. owing to the advantage of rapid heating, the alumina ceramics obtained by sps have a grain size and density comparable to those of hot pressed ones. the increase of densification rate may be related to some difference in ion transport characteristics. this study...
متن کاملSintering of Ceramics
Sintering with low frequency rf power (-50 M H z ) is a new technique with unique capabilities that has been used to sinter a variety of ceramic materials, including zirconia-toughened alumina, alumina, silicon carbide, and boron carbide. Processing with low frequencies offers many advantages compared to processing with conventional microwave frequencies (915 MHz and 2.45 GHz). Because of the l...
متن کاملSintering Behavior of 0.8 mol%-CuO-Doped 3Y-TZP Ceramics
In recent years, 3 mol% yttria-stabilized tetragonal zirconia polycrystals (3Y-TZP) doped with copper oxide has obtained increasing interest due to its enhanced superplastisity and good potential in tribological applications. In this work, the effect of addition of small amounts (0.8 mol%) of copper oxide on the sintering behavior of 3Y-TZP was studied using a dilatometer and high-temperature X...
متن کاملSintering Behavior and Properties of Iron-Rich Glass-Ceramics
Iron-rich glass-ceramics were obtained by the sintering of two glass powders, labeled G1 and G2, at heating rates of 5° and 20°C/min followed by an isothermal step in the 850°–1050°C temperature interval. The sintering process was evaluated by the linear shrinkage; the closed porosity was estimated by density measurements; the structure and the morphology of the glass ceramics were observed by ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Science of Sintering
سال: 2014
ISSN: 0350-820X,1820-7413
DOI: 10.2298/sos1401003l