Probabilistic analysis of voltage divider ratios

نویسندگان
چکیده

برای دانلود رایگان متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Nonlinear voltage divider

This paper is focused on how to implement a nonlinear voltage divider used in the electrical power network disturbances measurement system preconditioning circuit. The voltages acquired from the electrical power network have amplitudes between 0.2 kV and 10 kV, values which are very high for an acquisition board. These amplitudes must be reduced to the values accepted by the acquisition boards:...

متن کامل

A Novel Voltage Divider Circuit

 A novel analog divider is described in this paper. The circuit enables the division of a dc voltage with another dc voltage. The constant of the division is dependent upon a third dc voltage and a pair of resistors. Employing a precision source for the third dc voltage and matched resistors, an acceptable level of accuracy can be obtained. Keywords-sawtooth wave; integrator; comparator; analo...

متن کامل

PTAT Voltage Generator based on an MOS Voltage Divider

An MOS-only, proportional to absolute temperature (PTAT) voltage generator capable of operation in the whole range of inversion levels is presented. We perform a theoretical analysis based on the ACM model which is successfully compared to experimental data. PTAT voltages up to hundreds of milivolts at room temperature can be easily obtained.

متن کامل

Ultra Low Voltage Current Multiplier/divider

In this paper we are presenting novel current multiplier/divider circuits utilizing the power of FGUVMOS transistors. Even for ultra low supply voltages a proper operation is achieved with threshold shifting using post-fab. tuning. Measured results are provided of a multiplier working over a large magnitude in current at 0.7V power supply.

متن کامل

Seven Ports Power Divider with Various Power Division Ratios

A seven ports network is proposed to act as a six-way power divider/combiner. The proposed network structure consists of a set of λ/4 planar transmission lines at the design frequency and does not require any isolating resistor. The power divider is capable of providing various power ratios by judicious choice of the transmission lines characteristic impedances. Design equations are derived for...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: FME Transactions

سال: 2019

ISSN: 1451-2092,2406-128X

DOI: 10.5937/fmet1903624a