Process-level model evaluation: a snow and heat transfer metric
نویسندگان
چکیده
منابع مشابه
Heat and Mass Transfer in Leather Drying Process
Leather manufacturing involves a crucial energy-intensive drying stage in the finishing process to remove its residual moisture. Determining drying characteristics of leather is vitally important so as to optimize the drying stage. This paper describes an analytical way for determination of the drying characteristics of leather. The model presented, is based on fundamental heat and mass tra...
متن کاملAccumulated snow layer influence on the heat transfer process through green roof assemblies
A green roof can reduce the peak thermal cooling loads and reduce the building energy consumption during the summer. It is also necessary to understand the thermal performance of these green roof assemblies during the winter when affected by an accumulation of snow on the rooftops. This study presents an experimental investigation and discusses the snow influence on the heat transfer processes ...
متن کاملteacher educator evaluation model
اگرکیفیت معلم کلاس برای بهبودیادگیری دانش آموزحیاتی است،پس کیفیت اساتیددانشجو-معلمان، یابه عبارتی معلمین معلمان نیزبرای پیشرفت آموزش بسیارمهم واساسی است.ناگفته پیداست که یک سیستم مناسب آموزش معلمان ،معلمین با کیفیتی را تربیت خواهدکرد.که این کار منجربه داشتن مدارس خوب، ودرنتیجه نیروی کارماهرتروشهروندبهتربرای جامعه خواهدشد. اساتیددانشجو-معلمان نقشی بسیارمهم را در سیستم اموزش معلمان درسراسرجهان ای...
Fluid Flow and Heat Transfer of Nanofluids over a Flat Plate with Conjugate Heat Transfer
The falling and settling of solid particles in gases and liquids is a natural phenomenon happens in many industrial processes. This phenomenon has altered pure forced convection to a combination of heat conduction and heat convection in a flow over a plate. In this paper, the coupling of conduction (inside the plate) and forced convection of a non-homogeneous nanofluid flow (over a flat plate) ...
متن کاملHeat transfer enhancement in a spiral plate heat exchanger model using continuous rods
This study presents an innovative and simple way to increase the rate of heat transfer in a spiral plate heat exchanger model. Several circular cross-section rods, as continuous vortex generators, have been inserted within the spiral plate heat exchanger in the cross-stream plane. The vortex generators are located at various azimuth angles of α=30◦, 60◦, 90◦, and 120◦ with non-dimensional diame...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: The Cryosphere
سال: 2017
ISSN: 1994-0424
DOI: 10.5194/tc-11-989-2017