Processing of Al-Si Waste Contaminated with Iron by Powder Metallurgy
نویسندگان
چکیده
منابع مشابه
B4C-Al Composites Fabricated by the Powder Metallurgy Process
Due to the large thermal neutron absorption cross section of 10B, B4C-Al composites have been used as neutron absorbing materials in nuclear industries, which can offer not only good neutron shielding performance but also excellent mechanical properties. The distribution of B4C particles affects the mechanical performance and efficiency of the thermal neutron absorption of the composite materia...
متن کاملProduction and microstructural investigation of Al-nano TiB2 composite produced by powder metallurgy technique
Automotive and aerospace industries are required to light materials which have high properties. This causes to reduce production cost and fuel consumption. One of these advanced materials that have been attracted at these decades is particulate metal matrix nanocomposites. These materials have a combination of ductile matrix alloy properties and ceramic reinforcement nanoparticles. Powder metal...
متن کاملProduction and microstructural investigation of Al-nano TiB2 composite produced by powder metallurgy technique
Automotive and aerospace industries are required to light materials which have high properties. This causes to reduce production cost and fuel consumption. One of these advanced materials that have been attracted at these decades is particulate metal matrix nanocomposites. These materials have a combination of ductile matrix alloy properties and ceramic reinforcement nanoparticles. Powder metal...
متن کاملPorous, Superelastic NiTi Produced by Powder-Metallurgy
Near-stoichiometric NiTi was foamed in the solid state at elevated temperatures through creep expansion of highpressure argon pores previously entrapped during powder consolidation. A sample with 17% porosity was found to be superelastic up to a compressive stress of 800 MPa.
متن کاملToz Metalurji̇si̇ Yöntemi̇ İle Alümi̇nyum Köpük Üreti̇mi̇ Procuction of Al Foams by Powder Metallurgy Route
In this study pure Al and pre-alloyed Al alloy powders (Alumix 231Al-Cu %2.5-Mg %0.5–Si %14) with or without reinforcing elements were used to produce classical Al foam or spherical Al foam with various production parameters by using powder metallurgy route and the results obtained have been discussed. Al2O3 and SiC particles were used as reinforcing elements and TiH2 powders were used as foami...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Manufacturing Technology
سال: 2018
ISSN: 1213-2489,1213-2489
DOI: 10.21062/ujep/54.2018/a/1213-2489/mt/18/1/60