Processing of ceramic-metal interpenetrating composites
نویسندگان
چکیده
منابع مشابه
Wear of ceramic particle-reinforced metal-matrix composites
Wear experiments have shown that when the applied normal stress exceeds a critical value, a transition occurs from the regime of mild wear to that of adhesive wear. As a result, the wear rate of particle-reinforced aluminium composites increases by a hundred-fold. Based on dislocation and delamination theories, a criterion is proposed for determining the critical transition load, and a quantita...
متن کاملPorous Ceramic - Metal Composites Obtained by Infiltration Methods
A. Boczkowska, P. Chabera, Warsaw University of Technology, Faculty of Materials Science and Engineering, Warsaw, Poland A. J. Dolata, M. Dyzia, Silesian University of Technology, Faculty of Materials Science and Metallurgy, Katowice, Poland A. Oziębło, Institute of Ceramics and Construction Materials, Katowice, Poland A pressure-vacuum infi ltration (T = 720 oC, p = 15 MPa, t = 15 min) and gas...
متن کاملA micromechanical model for interpenetrating multiphase composites
The dependence relation between the macroscopic effective property and the microstructure of interpenetrating multiphase composites is investigated in this paper. The effective elastic moduli of such composites cannot be calculated from conventional micromechanics methods based on Eshelby s tensor because an interpenetrating phase cannot be extracted as dispersed inclusions. Employing the conce...
متن کاملMicrowave Heating of Ceramic Composites
The microwave heating of a ceramic composite is modelled and analysed. The composite consists of many small ceramic particles embedded in a ceramic cement. The composite is assumed to be well insulated, and each particle is assumed to be in imperfect thermal contact with the surrounding cement. Based on these two assumptions an asymptotic theory exploiting the small Biot number and small non-di...
متن کاملCeramic/metal Nanocomposites by Lyophilization: Processing and Hrtem Study
This work describes a wet-processing route based on spray-freezing and subsequent lyophilization designed to obtain nanostructured ceramic/metal powders. Starting from the ceramic powder and the corresponding metal salt, a water-based suspension is sprayed on liquid nitrogen. The frozen powders are subsequently freeze-dried, calcined and reduced. The material was analyzed using X-ray diffractio...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the European Ceramic Society
سال: 2009
ISSN: 0955-2219
DOI: 10.1016/j.jeurceramsoc.2008.07.034