Properties of 17-4 PH Stainless Steels Produced by Metal Injection Molding Process.
نویسندگان
چکیده
منابع مشابه
High-temperature Fatigue Crack Growth Behavior of 17-4 Ph Stainless Steels
The fatigue crack growth (FCG) behavior was investigated for 17-4 PH stainless steels in three heat-treated conditions, i.e., unaged (Condition A), peak-aged (Condition H900), and overaged (Condition H1150), at temperatures ranging from 300 to 500 C. The high-temperature fatigue crack growth rates (FCGRs) of Condition H1150 were increased with an increase in temperature. However, for Conditions...
متن کاملEvaluation of dissimilar joint properties of AISI316 to AISI430 stainless steels produced by GTAW
In this research, microstructure and mechanical properties of AISI316 to AISI430 dissimilar joint were investigated. For this purpose, GTAW process using ER316L and ER2209 filler metals with diameter of 2.4 mm was used. The microstructure and fracture surface of the welded samples were characterized by optical microscopy and scanning electron microscopy. Also the mechanical properties of the we...
متن کاملA Corrosion Study of Grain-Refined 304L Stainless Steels Produced by the Martensitic Process
AISI 304L austenitic stainless steel with different grain sizes of 0.5 -12 μm was obtained through the martensitic process. Corrosion behavior of different samples was investigated in a 0.5M HCl solution using open circuit potential, potentiodynamic polarization and electrochemical impedance spectroscopy tests. Also, the correlation between the grain size and pitting corrosion resistance was as...
متن کاملEvaluation of dissimilar joint properties of AISI316 to AISI430 stainless steels produced by GTAW
In this research, microstructure and mechanical properties of AISI316 to AISI430 dissimilar joint were investigated. For this purpose, GTAW process using ER316L and ER2209 filler metals with diameter of 2.4 mm was used. The microstructure and fracture surface of the welded samples were characterized by optical microscopy and scanning electron microscopy. Also the mechanical properties of the we...
متن کاملTowards sustainable machining of 17-4 PH stainless steel using hybrid MQL-hot turning process
The use of a minimum quantity of lubrication (MQL) with extremely low consumption of lubricant in machining processes has been reported as a technologically and environmentally feasible alternative to conventional flood cooling. In hot machining, the external heat source is applied during machining that will assist to increase machining performance. Many external heating techniques are availabl...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Society of Powder and Powder Metallurgy
سال: 1995
ISSN: 0532-8799,1880-9014
DOI: 10.2497/jjspm.42.1119