Properties of Kneading Extrusion Materials Molding by Molten Polyethylene Matrix
نویسندگان
چکیده
منابع مشابه
control of the optical properties of nanoparticles by laser fields
در این پایان نامه، درهمتنیدگی بین یک سیستم نقطه کوانتومی دوگانه(مولکول نقطه کوانتومی) و میدان مورد مطالعه قرار گرفته است. از آنتروپی ون نیومن به عنوان ابزاری برای بررسی درهمتنیدگی بین اتم و میدان استفاده شده و تاثیر پارامترهای مختلف، نظیر تونل زنی(که توسط تغییر ولتاژ ایجاد می شود)، شدت میدان و نسبت دو گسیل خودبخودی بر رفتار درجه درهمتنیدگی سیستم بررسی شده اشت.با تغییر هر یک از این پارامترها، در...
15 صفحه اولNeural Modeling of Parison Extrusion in Extrusion Blow Molding
Back-propagation (BP) neural network is used to develop process models for the parison extrusion in extrusion blow molding based on experimental data. In applying the BP network, some modifications, such as using a self-adaptive learning rate coefficient, determining the number of hidden neurons through experimentation, and so on, to the original BP algorithm are carried out to speed up learnin...
متن کاملStability of polyethylene oxide in matrix tablets prepared by hot-melt extrusion.
The thermal stability of polyethylene oxide (PEO) in sustained release tablets prepared by hot-melt extrusion was investigated. The weight average molecular weight of the polymer was studied using gel permeation chromatography. The chemical stability of PEO was found to be dependent on both the storage and processing temperature, and the molecular weight of the polymer. Storage of the polymer a...
متن کاملEffect of Particle Volume Fraction on the Tensile Properties of Composite Al6061/SiC Materials by Hot Extrusion
In the present study the effect of phase volume fraction on the reinforcement of microstructure and tensile properties of composite extrusion process Al6061/SiC has been studied. For this purpose, the base alloy Al6061 using pure aluminum ingots, silicon, of Al-50% Mg, Al-10% Cr and a thin copper rod was prepared. Next, the composite Al6061/5% SiC, Al6061/10% SiC, Al6061/15% SiC and Al6061/20% ...
متن کاملInjection Molding of Plastics from Agricultural Materials
OBJECTIVE DOE Chicago Operations %ice The objective of this research was to conduct a systematic study to relate injection molding parameters to properties of blends of starch and synthetic polymer. Blends of normal (25 % amylose) and high amylose (50 and 70% amylose) corn starch (containing between 60 and 70 % of the mixture by weight) and synthetic polymer were used in this research. Two diff...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Seikei-Kakou
سال: 2004
ISSN: 0915-4027,1883-7417
DOI: 10.4325/seikeikakou.16.125