Pulsating Flow Characteristics of Hot-Wire Air Flow Meter for Gasoline Fuel-Injection Systems.
نویسندگان
چکیده
منابع مشابه
Design of Air Distribution System for Operation Theatre Using Flow Visualization Techniques to Improve Flow Characteristics
Operation Theatre (OT) is the most important area where precise controlled on indoor air quality is required because it is directly related to patient health and its recovery period. This work aims to study and visualize the airflow distribution of conventional flat air diffuser ventilation system and newly designed angular air ventilation system in OT. Angular Air Distribution (AAD) system is ...
متن کاملThe wire-mesh sensor as a two-phase flow meter
A novel gas and liquid flow rate measurement method is proposed for use in vertical upward and downward gas–liquid pipe flows. This method is based on the analysis of the time history of area-averaged void fraction that is measured using a conductivity wire-mesh sensor (WMS). WMS measurements were collected in vertical upward and downward air–water flows in a pipe with an internal diameter of 3...
متن کاملThermal MEMS flow meter for gaseous working fluids on the basis of the hot-wire thermoanemometric sensor
This paper describes the main principles of constructing innovative MEMS flow meters for gaseous working fluids. MEMS flow meter contains hot-wire thermoanemometrisc sensor which response to the temperature change caused by convective working fluid heat transfer from a hot-wire. The advantages of using hot-wire thermoanemometric sensors were analyzed. The main emphasis of this work is on speed,...
متن کاملAn Investigation into Air Ejector with Pulsating Primary Flow
The article deals with pneumatic and hot wire anemometry measurement on subsonic axi-symmetric air ejector. Performances of the ejector with and without pulsations of primary flow are compared, measuring of characteristic pressures and mass flow rates are performed and ejector efficiency is evaluated. The pulsations of primary flow are produced by a synthetic jet generator, which is placed in t...
متن کاملK V Santhosh: Fusion of Venturi and Ultrasonic Flow Meter for Enhanced Flow Meter Characteristics Using Fuzzy Logic
This paper proposes a technique for measurement of liquid flow using venturi and ultrasonic flow meter(UFM) to have following objectives a) to design a multi-sensor data fusion (MSDF) architecture for using both the sensors, b) improve sensitivity and linearity of venturi and ultrasonic flow meter and c) detect and diagnosis of faults in sensor if any. Fuzzy logic algorithm is used to fuse outp...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: JSME International Journal Series B
سال: 1995
ISSN: 1340-8054,1347-5371
DOI: 10.1299/jsmeb.38.143