Pulse Edge-Only Signaling Method Comparison for Wireline Interconnects
نویسندگان
چکیده
منابع مشابه
Comparison of amplitude-optimised bit-edge equalisation with pulse-width modulation in high-speed wireline application
An amplitude-optimised bit-edge equalisation (BEE) scheme is presented and compared with pulse-width modulation for mitigating intersymbol interference in high-speed backplane applications. With transmitter pre-coding and pre-emphasis, this BEE uses an adaptive LMS algorithm as a receiver error convergence engine by adjusting error derivation points. The optimality of the proposed BEE scheme is...
متن کاملSufficient conditions for maximally edge-connected and super-edge-connected
Let $G$ be a connected graph with minimum degree $delta$ and edge-connectivity $lambda$. A graph ismaximally edge-connected if $lambda=delta$, and it is super-edge-connected if every minimum edge-cut istrivial; that is, if every minimum edge-cut consists of edges incident with a vertex of minimum degree.In this paper, we show that a connected graph or a connected triangle-free graph is maximall...
متن کاملUltra-low-power signaling challenges for subthreshold global interconnects
Demand of power efficient circuits has grown significantly due to fast growth of battery operated portable applications. Though, subthreshold operation of device shows huge potential towards satisfying the ULP requirement, it holds many challenging design issues. As integration density of interconnect increases at every technology node, increased delay and crosstalk become more challenging desi...
متن کاملDriver Pre - emphasis Signaling for On - Chip Global Interconnects
ZHANG, LIANG LEON. Driver Pre-emphasis Signaling for On-Chip Global Interconnects (Under the direction of Professor Paul D. Franzon). Signaling design for high performance VLSI systems has become an increasingly difficult task due to the delay/noise limitation for on-chip global interconnects. Repeater insertion techniques are widely used to improve the signal bandwidth of interconnect channels...
متن کاملMethod for Attaching Fluidic Interconnects using Resistively Heated Gold
Two methods of attaching fluidic interconnects are presented. By using gold to gold fusion bonding and copper to gold fusion bonding, micro-scale tubes are attached to a MUMPS fabricated fluidic channel. The fusion bonding is done by resistively heating a gold layer on top of the poly 2 layer, so that the gold melts. A range of different heater geometries is presented. The tensile and shear str...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Advances in Electrical Engineering
سال: 2014
ISSN: 2356-6655,2314-7636
DOI: 10.1155/2014/938460