Pulse shaping techniques for testing brittle materials with a split hopkinson pressure bar

High Rate Characterization of Low Impedance Materials Using a Polymeric Split Hopkinson Pressure Bar

The characterization of soft or low impedance materials is of increasing importance since these materials are commonly used in impact and energy absorbing applications. There is a need to measure the high-rate material properties of soft materials, where the mode of loading is predominantly compressive and large deformations may occur at high rates of deformation. Importantly, the competing eff...

Using the split Hopkinson pressure bar to validate material models.

This paper gives a discussion of the use of the split-Hopkinson bar with particular reference to the requirements of materials modelling at QinetiQ. This is to deploy validated material models for numerical simulations that are physically based and have as little characterization overhead as possible. In order to have confidence that the models have a wide range of applicability, this means, at...

Stress Equilibrium in the Split Hopkinson Pressure Bar Test

The compressive split Hopkinson pressure bar (SHPB) technique allows the stresses on each end of the specimen to be measured individually. Results are presented showing a large difference between these end pressures, depending on specimen length and loading rate. The mechanisms responsible are shown to be a combination of inertial forces and non-uniform deformation due to wave propagation. Impl...

Advancements in the Split Hopkinson Bar Test

A non-equilibrium approach to processing Hopkinson Bar bending test data: Application to quasi-brittle materials

The aim of this paper was to describe a method of analysing the test data recorded during a Hopkinson Bar bending test. This three-point dynamic bending test was designed for testing the strength of materials under dynamic loads. It is carried out on a specimen consisting of a beam placed on two supports, which is subjected to an impact. The use of Hopkinson Bar as supports makes it possible to...