Quantitative analysis of fatigue fracture surface by X-ray fractography.
نویسندگان
چکیده
منابع مشابه
Surface Hardness Measurment and Microstructural Characterisation of Steel by X-Ray Diffraction Profile Analysis
An X-ray diffraction line will broaden considerably when steels change into martensitic structure on quenching. The results presented in this paper show that X-ray diffraction technique can be employed for a rapid and nondestructive measurement of hardness of hardened steel. Measurement on various quenched and tempered steels showed that the breadth of its diffraction peak increased with increa...
متن کاملQuantitative Analysis by X-ray Diffraction
Certain minerals in soil clays may be directly estimated from diffraction line intensity and the mass absorption coefficient of the sample to the radiation used. The main advantages of the method described are that no internal standards or calibration charts are required, and any diffraction line of the component to be estimated may be chosen. The results obtained compare favourably with chemic...
متن کاملStudy of the Fatigue Fracture Surface Regions of Steels Using Microbeam Synchrotron X-Ray Diffraction
A cyclic plastic zone area near fatigue-fractured surface was studied using a back-reflection camera and high intensity, microbeam, synchrotron X-ray source (SR) in order to measure the variation of the stress intensity factor range (AK) along the fatigue fracture. The existence of subgrains within the cyclic plastic region was shown by the appearance of small spots in the Debye-Scgerrer rings ...
متن کاملDetermination of cristobalite phase content in ceramic cores using various X-ray quantitative phase analysis methods
The aim of this research is to investigate different X-ray based quantitative phase analysis methods for determination of cristobalite phase content in ceramic cores. For this purpose, four popular routes including peak absolute intensity method, relative intensity ratio method, direct or calibration method and internal standard (or Alexander-Klug) method have been chosen. Some control samples ...
متن کاملStudy on Fracture Analysis of (a+~) Dual Phase Stainless Steel Using X-ray Diffraction
In this study, X-ray fractography’)-‘) technique was applied to the (GZ+~) dual phase stainless steel. Effect of the rolling direction on fatigue properties was discussed. Residual stress near the surface was measured by using X-ray diffraction method to the depth direction. Relations between X-ray parameter and fracture mechanics parameter were examined. As the result, distribution of the phas...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Society of Materials Science, Japan
سال: 1989
ISSN: 1880-7488,0514-5163
DOI: 10.2472/jsms.38.607