Random lasing of microporous surface of Cr2+:ZnSe crystal induced by femtosecond laser
نویسندگان
چکیده
منابع مشابه
control of the optical properties of nanoparticles by laser fields
در این پایان نامه، درهمتنیدگی بین یک سیستم نقطه کوانتومی دوگانه(مولکول نقطه کوانتومی) و میدان مورد مطالعه قرار گرفته است. از آنتروپی ون نیومن به عنوان ابزاری برای بررسی درهمتنیدگی بین اتم و میدان استفاده شده و تاثیر پارامترهای مختلف، نظیر تونل زنی(که توسط تغییر ولتاژ ایجاد می شود)، شدت میدان و نسبت دو گسیل خودبخودی بر رفتار درجه درهمتنیدگی سیستم بررسی شده اشت.با تغییر هر یک از این پارامترها، در...
15 صفحه اولFemtosecond laser induced surface nanostructures on copper
This study demonstrated circular surface nanostructures and femtosecond laser-induced periodic surface structures (FLIPSS) for copper produced by a Ti:Sapphire femtosecond laser beam of wavelength 800 nm and duration 120 fs. The circular textured nanostrucres could be created by a single laser pulse. The nanostructures in the center of the heated spot diminish as laser fluence increases and a c...
متن کاملFemtosecond laser ablation of ZnO nanorods for two-photon-pumped random lasing and optical data storage
Femtosecond laser ablation based on two-photon absorption was employed to cut ZnO nanorods into uniform ZnO nanoparticles of deep subwavelength size. The fabricated ZnO nanoparticles possess a shorter mean transport length for photons at the emission wavelength and a much smaller scattering cross section at the pump wavelength, leading to highly efficient two-photon-pumped random lasing with a ...
متن کاملRandom lasing in Nd:LuVO4 crystal powder.
Room temperature random lasing action is demonstrated for the first time in a low concentrated neodymium doped vanadate crystal powder. Laser threshold and emission efficiency are comparable to the ones obtained in stoichiometric borate crystal powders. The present investigation provides a complete picture of the random lasing characteristics of Nd-doped vanadate powder both in the spectral and...
متن کاملFemtosecond Laser Micromachining of Single-crystal Superalloys
Investigations on femtosecond laser micromachining of single crystal superalloys with and without plasma-sprayed thermal barrier coatings were conducted under laser fluences ranging from 0.1 J/cm up to 160 J/cm. Micromachining was carried out in air using a titanium:sapphire laser system ( = 780 nm) operating at a repetition rate of 1 kHz and delivering individual pulses of ~150 fs duration. Th...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: AIP Advances
سال: 2015
ISSN: 2158-3226
DOI: 10.1063/1.4923317