Rapid prototyping technology for silicone auricular prosthesis fabrication: A pilot study
نویسندگان
چکیده
منابع مشابه
Fabrication of a Silicone Auricular Prosthesis – A Case Report
The rehabilitation of a patient with facial defects is a challenging task. An alternative to surgical reconstruction is the creation of a silicone auricular prosthesis. The replacement of anatomical parts is an art and science. These prostheses provide a cost-effective and an acceptable means of camouflage for patients who are disinclined to surgical reconstruction. The process of creating a si...
متن کاملfabrication of a cranial prosthesis combined with an ocular prosthesis using rapid prototyping: a case report
rapid prototyping (rp) is a technique of manufacturing parts by the additive layer manufacturing technology; where, a three-dimensional (3d) model created in a computer aided design (cad) system is sectioned into 2d profiles, which are further constructed by rp layer by layer. its use is not limited to industrial or engineering fields and has extended to the medical field for the manufacturing ...
متن کاملBioceramic Scaffolds Fabrication by Rapid Prototyping Technology
This paper describes a rapid prototyping (RP) technology for forming a hydroxyapatite (HA) bone scaffold model. The HA powder and a silica sol are mixed into bioceramic slurry form under a suitable viscosity. The HA particles are embedded in the solidified silica matrix to form green parts via a wide range of process parameters after processing by selective laser sintering (SLS). The results in...
متن کاملComparison of two impression techniques for auricular prosthesis: pilot study.
The purpose of this article was to compare the accuracy of a new impression technique, the triple-layer impression technique (TLIT), with the conventional impression technique (CIT) to fabricate an auricular prosthesis. Fifteen male subjects (aged 22-45 yr) were selected. Ten markings were made on the subject's ear (super aurale [sa], sub aurale [sba], pre aurale [pra], post aurale [poa], A, A1...
متن کاملFabrication of a Cranial Prosthesis Combined with an Ocular Prosthesis Using Rapid Prototyping: A Case Report
Rapid prototyping (RP) is a technique of manufacturing parts by the additive layer manufacturing technology; where, a three-dimensional (3D) model created in a computer aided design (CAD) system is sectioned into 2D profiles, which are further constructed by RP layer by layer. Its use is not limited to industrial or engineering fields and has extended to the medical field for the manufacturing ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Head and Neck Physicians and Surgeons
سال: 2021
ISSN: 2347-8128
DOI: 10.4103/jhnps.jhnps_22_21