Re-amorphization of GeSbTe alloys not through a melt-quenching process

A COMPARISON OF THE REPRODUCIBILITY AND HOMOGENEITY OF AMORPHOUS Cu-Zr ALLOYS PREPARED BY ROLLER-QUENCHING AND MELT SPINNING

Melt Protection of Mg-Al Based Alloys

This paper reports the current status of Mg melt protection in view to identify near-future challenges, but also opportunities, for Mg melt protection of Mg-Al based alloys. The goal is to design and manufacture sustainable Mg alloys for resource efficiency, recycling and minimising waste. Among alternative cover gas technologies for Mg melt protection other than SF6: commercially available tec...

Fabrication and Structural Characterization of Se-Ge Chalcogenide Glasses by Means of Melt Quenching Technique

The structural and optical characterization of Se-Ge alloys during melt quenching technique was the goal of this study. In this regards, five different samples of Se100-xGex (x= 10, 20, 30, 40, 50) were prepared by conventional melt quenching in quartz ampoule. The produced samples were characterized using X-ray diffraction (XRD), scanning electron microscopy (SEM), differential scanning calori...

Atomistic origin of rapid crystallization of Agdoped GeSbTe alloys: A joint experimental and theoretical study

We have applied extended X-ray absorption fine structure (EXAFS) analyses and ab initio molecular dynamics (AIMD) simulations to study the structure of Ag-doped (up to 42%) Ge1Sb2Te4 alloys. The computer models are consistent with EXAFS experiments, and reveal that the Ge environment is significantly modified by Ag doping, whereas those of Sb and Te are barely affected (except for high Ag conce...

Effects of Melt Pool Variables and Process Parameters in Laser Direct Metal Deposition of Aerospace Alloys

Despite considerable advances in of laser direct metal deposition (LDMD) process optimization, there is rather limited work reported on the effects of melt pool variables on the final deposit characteristics. This article considers the effects of process parameters and melt pool characteristics on the deposition of Inconel 718 powder on a Ti-6Al-4V thin wall. A 1.5kW diode laser and LDMD system...