Reaction between Fe-Zn Alloy Layer and Zn-Al Melt.
نویسندگان
چکیده
منابع مشابه
DAMPING CAPACITY AND MECHANICAL PROPERTIES OF Zn-Al ALLOY CASTINGS
This paper describes damping capac i t y and mechanical p roper t ies o f Zn-8-20%A1 and Zn-8-20%Al-0.02-0.04XMg a l l o y cast ings. Zn-8-20%A1 a l l o y casti ngs show h igh damping when quenched from 573K. Small amount o f Mg a d d i t i o n t o these a l l o y cast ings lowers damping capaci ty considerably b u t e f f e c t i v e t o reduce decomposition through aging a t 423K f o r 48hrs ...
متن کاملMicrostructure of Al-Zn and Zn-Al Alloys*
The change of microstructure of the title alloys with concentration, temperature and applied thermal treatment was studied in situ by XRD. The alloys, having the Zn atomic fraction, x(Zn), from 0.03 to 0.62, were subjected to: (i) rapid quenching from a temperature, Tt, higher than the solid-solution temperature, Tss, in water at RT (samples WQ); (ii) slow cooling from Tt to RT (samples SC). Th...
متن کاملVoltammetric Determination of Zn(II) in Zn-Fe Alloy Electroplating Baths Using Square-Wave Voltammetry
Desenvolveu-se um método de análise de rotina para a determinação quantitativa de zinco em banhos de galvanoplastia de liga Zn-Fe através da técnica de voltametria de onda quadrada utilizando-se, como eletrodo de trabalho, o eletrodo de gota estática de mercúrio. Amostras reais de banhos de liga foram analisadas sem pré tratamento através do método de adição de padrão. Também foram feitos teste...
متن کاملShape Memory Properties in Cu-Zn-Al Alloy
In this research a Cu-Zn-Al alloy is produced by melting the raw materials in an electric resistance furnace and then pouring it into a steel mould. The optimum way to achieve the final analysis in the hypo-eutectoid range is determined and the influence of the alloying element, Ti on the grain size and the shape memory properties of the samples are investigated. Solution treatment (done at 850...
متن کاملShape Memory Properties in Cu-Zn-Al Alloy
In this research a Cu-Zn-Al alloy is produced by melting the raw materials in an electric resistance furnace and then pouring it into a steel mould. The optimum way to achieve the final analysis in the hypo-eutectoid range is determined and the influence of the alloying element, Ti on the grain size and the shape memory properties of the samples are investigated. Solution treatment (done at 850...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Surface Finishing Society of Japan
سال: 1997
ISSN: 0915-1869,1884-3409
DOI: 10.4139/sfj.48.1012