Reaction heat sintering using HIP - Densification of TiC-Ni composites.
نویسندگان
چکیده
منابع مشابه
Synthesis and Sintering of Ti3SiC2–SiC Composites through Reactive Hot-Pressing of TiC and Si Precursors
MAX phases are an attractive class of layered solids that have recently attracted a great deal of attention due to their unusual and unique composition. The ternary compound Ti3SiC2 is an example of a material that combines the properties of ceramics and metals. As a ceramic, they are high stiff. Some of them are resistant to oxidation, creep, fatigue, corrosion. They are extremely refractory a...
متن کاملFull densification of Molybdenum powders using Spark Plasma Sintering
Pure molybdenum powder was sintered using Spark Plasma Sintering under various temperatures, and holding times, under a pressure of 77 MPa and a heating rate at 700°C/min. After sintering, a carbide layer was observed at the surface. The carbide layer thickness, the relative density of the sample as well as the microhardness and the grain size of Mo were measured. The carbide thickness depends ...
متن کاملEffect of Ni content on the reaction behaviors and microstructure of TiB2-TiC/Ni cermets synthesized by MASHS
In this paper TiB2-TiC/Ni cermet with various Ni (20, 40 and 60 wt %) content were synthesized by mechanically activated self-propagating synthesis (MASHS) and effect of the addition of Ni on synthesis parameters and microstructure of synthesized samples were investigated. First raw materials (B4C, Ti and Ni) milled in Ar atmosphere. Then milling powders analyzed by XRD. In next step powders sy...
متن کاملInvestigation of Effective Parameters on Densification of ZrB2-SiC Based Composites Using Taguchi Method
Abstract The main goal of this study is optimization of densification of ZrB2-SiC composites reinforced with chopped Cf prepared by SPS. Taguchi method is employed as statistical design of experiment (DOE) to optimize densification parameters including SiC, Cf, MoSi2, HfB2 and ZrC content, milling time of Cf and SPS parameters such as temperature, time and pressure. Each of these factors ...
متن کاملProbing the densification mechanisms during flash sintering of ZnO
Using ZnO as a model system, the densification mechanisms of flash sintering are investigated. Controlled experiments via limiting the maximum current or the effective ramp rate suggest that both the maximum specimen temperature and the high heating rate (on the order of 200 C/s) are essential for the rapid densification during the flash sintering. Moreover, benchmarking rapid thermal annealing...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Society of Powder and Powder Metallurgy
سال: 1990
ISSN: 0532-8799,1880-9014
DOI: 10.2497/jjspm.37.1013