Reactive Spark Plasma Sintering: Successes and Challenges of Nanomaterial Synthesis
نویسندگان
چکیده
منابع مشابه
Spark Plasma Synthesis (SPS) Device for Sintering of Nanomaterials
It is known that work pieces with nanocrystalline structure condition have much higher performance than those with an ordinary structure. There are known number of techniques for manufacturing of nanocrystalline materials in powder condition however a question of manufacturing bulk pieces in the same nanocrystalline state mentioned is that compaction and synthesizing of nanocrystalline powders ...
متن کاملIN SITU FABRICATION OF Al 2024-Mg2Si COMPOSITE BY SPARK PLASMA SINTERING OF REACTIVE MECHANICALLY ALLOYED POWDER
In situ Al2024- Mg2Si composite was fabricated by spark plasma sintering (SPS) of reactive powder. Reactive powder was obtained from mechanical alloying (MA) of elemental powders. Clad layers of in situ composite were fabricated on Al substrates by spark plasma sintering (SPS). Structural evolution during MA process and after SPS was investigated by X-ray diffractometery (XRD). Scanning electro...
متن کاملChallenges and Opportunities for Spark Plasma Sintering: A Key Technology for a New Generation of Materials
Spark plasma sintering (SPS) or pulsed electric current sintering (PECS) is a sintering techni‐ que utilizing uniaxial force and a pulsed (on-off) direct electrical current (DC) under low at‐ mospheric pressure to perform high speed consolidation of the powder. This direct way of heating allows the application of very high heating and cooling rates, enhancing densifica‐ tion over grain growth p...
متن کاملSynthesis and Thermoelectric Properties of Copper Sulfides via Solution Phase Methods and Spark Plasma Sintering
Large-scale Cu2S tetradecahedrons microcrystals and sheet-like Cu2S nanocrystals were synthesized by employing a hydrothermal synthesis (HS) method and wet chemistry method (WCM), respectively. The morphology of α-Cu2S powders prepared by the HS method is a tetradecahedron with the size of 1–7 μm. The morphology of β-Cu2S is a hexagonal sheet-like structure with a thickness of 5–20 nm. The resu...
متن کاملFabrication of Nanostructured Cu matrix Nanocomposites by High Energy Mechanical Milling and Spark Plasma Sintering
Spark plasma sintering (SPS) is a sintering process that is capable of sintering hard worked powders in short times. This technique was used to fabricate bulk Cu and Cu-SiC nanocomposites. Pure Cu and mixed powders of Cu including 4 vol% of SiC nanoparticles were mechanically alloyed for 25 h and sintered at 750˚C under vacuum condition by SPS method. Microstructures of the materials were chara...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Nanomaterials
سال: 2013
ISSN: 1687-4110,1687-4129
DOI: 10.1155/2013/625218