Real-Time Temperature Control of Shell and Tube Heat Exchanger by IMC based PID controller
نویسندگان
چکیده
Shell and Tube Heat Exchanger is most widely used efficient heat exchanger in industries. The outlet temperature of the shell tube system has to be kept at a desired set point according process requirement by using controllers. Many controllers such as PID, feedback plus feed forward, Fuzzy logic, Internal Model based PID controller are control temperature. objective hot fluid manipulating inlet cold flow rate. transfer function obtained energy balance equations. Designing Controller done conventional Cohen-Coon tuning method advanced IMC method. closed loop results both responses for various changes disturbance studied. experiment MATLAB simulations carried out above parameters CC-PID IMC-PID data noted different points. Comparison made between simulations. And compared On comparing results, we can demonstrate that gives better terms lesser overshoot faster settling time. present work emphasis about experimental demonstration model (IMC) general control.
منابع مشابه
An Improved PID controller Design based on Model Predictive Control for a Shell and Tube Heat Exchanger
In this paper an algorithm of PID controller based on model predictive control is designed for a shell and tube heat exchanger. PID controllers and model predictive controls are two control algorithm mostly used these types of process applications. The three parameters of PID controller must be tuned to the process to obtain a satisfactory closed loop process performance. The model of the heat ...
متن کاملNonlinear Control Of A Shell And Tube Heat Exchanger
The paper deals with design and simulation of nonlinear adaptive control of a shell and tube heat exchanger. The method is based on factorization of the controller on a nonlinear static part and an adaptive linear dynamic part. The nonlinear static part is derived using inversion and subsequent exponential approximation of simulated or measured steady-state characteristics of the exchanger. The...
متن کاملEffect of baffle oientation on shell tube heat exchanger performance
In this paper, fluid flow and heat transfer in the laboratory (small size) shell tube heat exchanger are analysed by computational fluid dynamic software. In this type of shell tube heat exchanger baffles with different angles of rotation: 00 (horizontal segmental baffle), 150 (from horizontal), 300, 450, 600, 750, 900 (vertical segmental baffle) is used. Effect of baffle orientation on shell t...
متن کاملOptimal Design of Shell-and-Tube Heat Exchanger Based on Particle Swarm Optimization Technique
The paper studies optimization of shell-and-tube heat exchangers using the particle swarm optimization technique. A total cost function is formulated based on initial and annual operating costs of the heat exchangers. Six variables – shell inside diameter, tube diameter, baffle spacing, baffle cut, number of tube passes and tube layouts (triangular or square) – are considered as the design para...
متن کاملExperimental Studies and Controller Design of Shell and Tube Heat Exchanger Using With and Without Insert
An experimental study of heat transfer characteristics with and without insert was found using water –water system on 1-2 pass shell and tube heat exchanger. Experimental results such as exchanger effectiveness, overall heat transfer coefficient were calculated using with and without insert. There is improvement in overall heat coefficient, efficiency in using twisted tape. In all the process i...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: EPiC series in computing
سال: 2023
ISSN: ['2398-7340']
DOI: https://doi.org/10.29007/dgt1