Realization of Micro-EDM under Ultra-Small Discharge Energy by Applying Ultrasonic Vibration to Machining Fluid
نویسندگان
چکیده
منابع مشابه
Ultrasonic Vibration Assisted Electro-Discharge Machining
An ultrasonic vibration has been superposed on the normal electrode movement to increase the flushing effect during a micro electro-discharge machining (EDM) process. A systematic study on the effects of ultrasonic vibration on the EDM performance for fabricating microholes in Nitinol has been completed. The introduction of ultrasonic vibration to the microEDM process has more than 60 times inc...
متن کاملAccuracy improvement in nanographite powder-suspended dielectric fluid for micro-electrical discharge machining processes
Micro-electric discharge machining (μ-EDM) is an important manufacturing process that is able to produce components and tools with micro-features. Improvement to this process has resulted in the use of powder mixed dielectric (PMD), which results in better surface quality and faster machining time. However, the presence of conductive powder in the dielectric fluid negatively affects the accurac...
متن کاملBatch Mode Micromanufacturing Based on Micro Electro-discharge Machining and Micro Ultrasonic Machining for Micro Electro Mechanical Systems (mems)
Metal alloys have material properties that are very appealing for micro electro mechanical systems (MEMS), but present a challenge for process integration within a lithographic manufacturing sequence of the type used in the semiconductor industry. The batch-mode micro electrodischarge machining (μEDM) discussed here uses lithographically-fabricated electrode arrays with high density and high un...
متن کاملFabrication of Microstructures on RB-SiC by Ultrasonic Cavitation Assisted Micro-Electrical Discharge Machining
∗Department of Mechanical Systems and Design, Tohoku University 6-6-01 Aoba, Aramaki, Aoba-ku, Sendai 980-8579, Japan E-mail: [email protected] ∗∗Department of Mechanical Engineering, Faculty of Science and Technology, Keio University 3-14-1 Hiyoshi, Kohoku-ku, Yokohama 223-8522, Japan ∗∗∗Manufacturing Process Department, Faculty of Manufacturing Engineering, Universiti Teknikal Malay...
متن کاملThermal Analysis of Workpiece under Electrical Discharge Machining (EDM), Using Hyperbolic Heat Conduction Model
Whereas in electrical discharge machining (EDM) the heat flux entering the workpiece is extremely high, the Fourier heat conduction model may fails. This article reports on determination of temperature distribution in the workpiece due to EDM using non-Fourier heat conduction model. Equations are solved by deriving the numerical solution. The temperature layers and profiles of sample calculatio...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Procedia CIRP
سال: 2013
ISSN: 2212-8271
DOI: 10.1016/j.procir.2013.03.094