Reconstruction of high temperature deformation process in Zr-based alloys
نویسندگان
چکیده
منابع مشابه
Investigation on Deformation and Wear of Zr-based Amorphous Alloys
Nanoindentation with spherical and Berkovich indenters, reciprocating wear and dynamic impact tests were conducted to investigate the deformation and wear behavior of two Zr-based metallic glasses. The results indicated that the indenter shape may have an effect on the displacement bursts in the load-penetration curves as no apparent bursts could be observed when a Berkovich indenter was used. ...
متن کاملHigh Temperature Erosion- Oxidation Behavior of Nickel- Based Alloys Containing Mo in Fluidized Bed Waste Incineration
High-temperature erosion-oxidation behavior of nickel-based alloys containing 0-7 wt.% Mo in fluidized bed waste incineration conditions was studied. A stream of hot condensed air with a flow rate of 25 L/min caused hot silica sand (700 °C) mixed with 0.5 wt.% of chloride salts to hit the specimens for 250 h. By removing the erosive factor, the high-temperature oxidation behavior of the alloys ...
متن کاملDeformation and crystallization of Zr-based amorphous alloys in homogeneous flow regime
The purpose of this study is to experimentally investigate the interaction of inelastic deformation and microstructural changes of two Zr-based bulk metallic glasses (BMGs): Zr41.25Ti13.75Cu12.5Ni10Be22.5 (commercially designated as Vitreloy 1 or Vit1) and Zr46.75Ti8.25Cu7.5Ni10Be27.5 (Vitreloy 4, Vit4). High-temperature uniaxial compression tests were performed on the two Zr alloys at various ...
متن کاملHigh Temperature Deformation of Twin-Roll Cast Al-Mn-Based Alloys after Equal Channel Angular Pressing
Twin roll cast Al-Mn- and Al-Mn-Zr-based alloys were subjected to four passes of equal channel angular pressing. The resulting grain size of 400 nm contributes to a significant strengthening at room temperature. This microstructure is not fully stable at elevated temperatures and recrystallization and vast grain growth occur at temperatures between 350 and 450 °C. The onset of these microstruct...
متن کاملHigh-temperature dislocation-precipitate interactions in Al alloys: An in situ transmission electron microscopy deformation study
The fundamental processes controlling the high-temperature interaction of dislocations with precipitates in Al-alloys were investigated in real time by deforming specimens in situ in the transmission electron microscope at elevated temperature. The observations support a bypass mechanism involving the interaction of lattice dislocations with the precipitate–matrix interface dislocations, where ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Acta Crystallographica Section A Foundations of Crystallography
سال: 2007
ISSN: 0108-7673
DOI: 10.1107/s0108767307093610