Recrystallization in Fe-Al-N Alloy
نویسندگان
چکیده
منابع مشابه
FRACTIONAL RECRYSTALLIZATION KINETICS IN DIRECTLY COLD ROLLED Al-Mg, Al-Mg-Sc AND Al-Mg-Sc-Zr ALLOY
The evaluation of texture as a function of recrystallization has been characterized for directly cold rolled Al-6Mg, Al-6Mg-0.4Sc and Al-6Mg-0.4Sc-0.2Zr alloys. Samples were annealed isothermally at 400 °C for 1 to 240 minutes to allow recrystallization. Recrystallization kinetics of the alloys is analyzed from the micro-hardness variation. Isothermally annealed samples of aluminum alloys were ...
متن کاملEffect of heterogeneously distributed pre-existing dispersoids on the recrystallization behavior of a cold-rolled Al-Mn-Fe-Si alloy
a r t i c l e i n f o It is well known that strong concurrent precipitation, mainly located along grain/subgrain boundaries, results in a coarse and elongated grain structure, and unusual sharp P {011} b566N and/or M {113} b110N texture components during annealing of supersaturated AA3xxx-series alloys. In this study, a supersaturated as-cast Al–Mn– Fe–Si alloy was annealed at three temperature...
متن کاملPhase Separation kinetics in Fe-Cr-Al alloy
9 The α α phase separation kinetics in a commercial Fe-20 wt% Cr-6% Al oxide dispersion-strengthened PM 1
متن کاملAccelerated learning using Gaussian process models to predict static recrystallization in an Al–Mg alloy
This paper describes an investigation into the suitability of Gaussian process models for predicting the microstructure evolution arising from static recrystallization. These methods have the advantage of not requiring a prior understanding of the micromechanical processes. They are wholly empirical and use a Bayesian framework to infer the probability distribution of data, given a ‘training se...
متن کاملLocalized Recrystallization in Cast Al-Si-Mg Alloy During Solution Heat Treatment: Dilatometric and Calorimetric Studies
During heat treatment, the work piece experiences a range of heating rates depending upon the sizes and types of furnace. When the Al-Si-Mg cast alloy is heated to the solutionizing temperature , recrystallization takes place during the ramp-up stage. The effect of heating rate on recrystallization in the A356 (Al-Si-Mg) alloy was studied using dilatometric and calorimetric methods. Recrystalli...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Tetsu-to-Hagane
سال: 1970
ISSN: 0021-1575,1883-2954
DOI: 10.2355/tetsutohagane1955.56.13_1726