Relation between Sinter Microstructures and Sinter Properties during Reduction
نویسندگان
چکیده
منابع مشابه
Harmful Admixtures Assessment in Sinter Mixtures Used in Iron Ore Sinter Plants in Poland
J. Korol, Central Mining Institute, Department of Material Engineering, Poland D. Burchart-Korol, A. Smoliński, Central Mining Institute, Department of Energy Saving and Air Protection, Poland In this study composition of sinter mixtures used in Polish sinter plants were established. Seven sinter mixtures composition were examined, based on iron-bearing materials, admixtures and fuels.
متن کاملMineralogical and textural changes accompanying ageing of silica sinter
Twenty nine samples of silica sinter, ranging in age from modern to Miocene, record temporal changes in both mineralogy and texture. When ®rst deposited, sinters consist largely of noncrystalline spheres (<1±8 lm diameter) of opal-A exhibiting varying degrees of closepacking. Particle densities range from 1.5 to 2.1 g cm, total water 4±10 wt%, and porosities 35±60%. Changes over 10,000 years fo...
متن کاملImprovement of mechanical properties of zirconia-toughened alumina by sinter forging
ZTA powder with a composition of 85 wt% alumina/15 wt% zirconia was prepared by a gel precipitation method. Sinter forging was performed with this powder to enhance the mechanical properties of ZTA materials. The influence of processing flaws on mechanical properties of sinter forged materials and pressureless sintered materials was investigated. Sinter forging at 40 MPa effectively decreases p...
متن کاملModeling and Simulation of Press and Sinter Powder Metallurgy
EFFECTIVE COMPUTER SIMULATIONS of metal powder compaction and sintering are at the top of the powder metallurgy industry’s wish list. There is much anticipated advantage to such efforts, yet there are problems that will inhibit widespread implementation. Press-sinter powder metallurgy computer simulations currently focus on the use of minimal input data to help with process setup. Although the ...
متن کاملEffect of Tempering Temperature on Mechanical Properties and Microstructure of Sinter Hardened Materials
Sinter hardening enables the production of P/M parts with high strength and apparent hardness after sintering, eliminating the need for a post sintering heat treatment. The availability of sintering furnaces with improved cooling capacity combined with the development of low alloy steel powders specifically designed for sinter hardening make this process particularly attractive for parts that a...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Tetsu-to-Hagane
سال: 1982
ISSN: 0021-1575,1883-2954
DOI: 10.2355/tetsutohagane1955.68.15_2215