Removing Redundancy in Partial Discharge Cables Using Continuous Wavelet Transform
نویسندگان
چکیده
منابع مشابه
gravity sources identification using continuous wavelet transform
introduction: wavelet transform is one of the useful and suitable tools for time series and signal analysis. nowadays wavelet transform is frequently used in geophysical data processing and interpretation, especially seismic data. however, the use of this method isn’t widespread in gravity and geomagnetic. fedi and quarta (1998), martelet et al. (2001) and de oliveira lyrio (2004) used the wave...
متن کاملNoise Reduction of Partial Discharge Signals Using Linear Prediction and Wavelet Transform
Partial discharges are caused by various defects such as voids, shield protrusions, contaminants, advanced stages of water tree, etc and known the main cause of breakdown in insulation materials. Partial discharge (PD) location is a powerful and useful tool for the maintenance and operation of electrical power distribution cables. This paper describes the application of two digital signal-proce...
متن کاملUsing PCA with LVQ, RBF, MLP, SOM and Continuous Wavelet Transform for Fault Diagnosis of Gearboxes
A new method based on principal component analysis (PCA) and artificial neural networks (ANN) is proposed for fault diagnosis of gearboxes. Firstly the six different base wavelets are considered, in which three are from real valued and other three from complex valued. Two wavelet selection criteria Maximum Energy to Shannon Entropy ratio and Maximum Relative Wavelet Energy are used and compared...
متن کاملR-peak Detection in Electrocardiogram Signals Using Continuous Wavelet Transform
In this paper, an efficient wavelet-based method is proposed to detect the R-peak from QRS complex. At first, a preprocessing step is taken to remove high frequency noise of electrocardiogram (ECG) data. Then, continuous wavelet transform (CWT) is applied to the signal and the R-peaks of QRS complexes are detected with acceptable accuracy using special thresholding method. The detection perform...
متن کاملDamage identification of structures using experimental modal analysis and continuous wavelet transform
Abstract: Modal analysis is a powerful technique for understanding the behavior and performance of structures. Modal analysis can be conducted via artificial excitation, e.g. shaker or instrument hammer excitation. Input force and output responses are measured. That is normally referred to as experimental modal analysis (EMA). EMA consists of three steps: data acquisition, system identificatio...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Research Journal of Applied Sciences
سال: 2011
ISSN: 1815-932X
DOI: 10.3923/rjasci.2011.150.152