Research on low-temperature anodic bonding using induction heating
نویسندگان
چکیده
منابع مشابه
Low Invasive Temperature Monitoring Method for Hyperthermia Using Induction Heating
In this study, we develop a local heating method and monitoring method for hyperthermia using the Ferromagnetic Implant with Low Curie Temperature (FILCT) under a high frequency magnetic field. We describe the experimental setup and in vitro experimental results.
متن کاملDirect Silicon–Silicon Bonding by Electromagnetic Induction Heating
A novel heating technique, electromagnetic induction heating (EMIH), uses electromagnetic radiation, ranging in frequency from a few megahertz to tens of gigahertz, to volumetrically heat silicon above 1000 C in only a few seconds. Typical power requirements fall between 900 to 1300 W for silicon wafers 75 to 100 mm in diameter. This technique has successfully produced direct silicon wafer-to-w...
متن کاملPerformances of Low Temperature Radiant Heating Systems
The low temperature radiant systems are very complex because they involve different mechanisms of heat transfer: heat conduction through the walls, heat convection between the heating panel and the indoor air, heat radiation between the heating panel and the surrounding areas, and the heat conduction between the floor and the ground. The main essence of the low-temperature air systems is to pro...
متن کاملLow temperature bonding technology for 3D integration
0026-2714/$ see front matter 2011 Elsevier Ltd. A doi:10.1016/j.microrel.2011.03.038 ⇑ Corresponding author. E-mail address: [email protected] (K.-N. C 3D integration provides a promising solution to achieve system level integration with high function density, small form factor, enhanced transmission speed and low power consumption. Stacked bonding is the key technology to enable the comm...
متن کاملStudy on the Glass Silicon Anodic Direct Bonding Parameters
By MEMS packaging test platform for bonding process of bonding temperature and bonding time, and test silicon specifications experimental study. Experimental results indicate that when the bonding voltage of 1200V, bonding temperature of 445 0 C to 455 0 C, bonding time is 60s, the void fraction is less than 5%. Glass and silicon wafer bonding quality can achieve the best. The experimental resu...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Physics: Conference Series
سال: 2006
ISSN: 1742-6588,1742-6596
DOI: 10.1088/1742-6596/34/1/161