Research Trend of Laser Welding and Weldability of High Speed Dissimilar Laser Lap Welding for Titanium

Femtosecond fiber laser welding of dissimilar metals.

In this paper, welding of dissimilar metals was demonstrated for the first time, to the best of our knowledge, by using a high-energy high-repetition-rate femtosecond fiber laser. Metallurgical and mechanical properties were investigated and analyzed under various processing parameters (pulse energy, repetition rate, and welding speed). Results showed that the formation of intermetallic brittle...

Control of Welding Residual Stress for Dissimilar Laser Welded Materials

The most common problem of welding dissimilar metals (DMWs) with respect to residual stresses is the differences in the coefficient of thermal expansion and heat conductivity of the two welded metals. In the present work, a CO2 continuous laser welding process was successfully applied and optimized for joining a dissimilar AISI 316 stainless steel and low carbon steel plates. The Taguchi approa...

Nd:YAG laser welding in Titanium-6242

Laser welding of dissimilar aluminium alloys with filler material

Laser welding of dissimilar aluminium alloys with filler material Luís Filipe Amaro Pinto Instituto Superior Técnico – Technical University of Lisbon – Portugal September 2008 Abstract The aluminium alloys are materials with great potential because of its high strength and low weight. However, the welding of dissimilar aluminium alloys is difficult in autogeneous welding, due to these alloys ar...

Laser Welding of Titanium and Dental Precious Alloys

The performance of laser welding of Ti and two dental precious alloys (Ag-Pd-Au, Au-Pt-Ag) was investigated by mechanical testing and microscopic observation, using butt joint as design. The laser irradiation was done using a commercial Nd:YAG dental laser-welding device in a single pulse mode with output currents 150, 200, 250, 300A, spot diameters 0.6, 0.9, 1.2mm, and pulse duration 10ms. The...