RESIDUAL AXIS LOAD CAPACITY OF REINFORCED CONCRETE COLUMNS AFTER SHEAR COMPRESSION FAILURE IN BENDING HINGE ZONE
نویسندگان
چکیده
منابع مشابه
Residual strength of blast damaged reinforced concrete columns
Columns are the key load-bearing elements in frame structures and exterior columns are probably the most vulnerable structural components to terrorist attacks. Column failure is normally the primary cause of progressive failure in frame structures. A high-fidelity physicsbased computer program, LS-DYNA was utilized in this study to provide numerical simulations of the dynamic responses and resi...
متن کاملplastic hinge rotation capacity of reinforced concrete beams
a parametric study is performed to assess the influence of the tension reinforcement index, ( ω = ρ fy /f bc), and the bending moment distribution (loading type) on the ultimate deformation characteristics of reinforced concrete (rc) beams. the analytical results for 15 simply supported beams with different amounts of tension reinforcement ratio under three different loading conditions are pres...
متن کاملRehabilitation of Reinforced Concrete Columns
In recent years, rehabilitation has been the subject of extensive research due to increased spending on building work and repair of built works. In all cases, it is absolutely essential to carry out methods of strengthening or repair of structural elements, and that following an inspection analysis and methodology of a correct diagnosis. The reinforced concrete columns are important elements in...
متن کاملReinforced Concrete Columns in Torsion (RESEARCH NOTE).
ACT does not suggest any regulations for columns under torsion. However, by all means, the number of such columns used in steel and concrete structures is abundant. In this paper, using the results of laboratory tests on 35 square and rectangular columns with intermediate slender ratios, relations for determination of torsional strengths of reinforced concrete under axial compression have been ...
متن کاملDevelopment of Shear Capacity Equations for Rectangular Reinforced Concrete Beams
The problem of shear is not yet fully understood due to involvement of number of parameters. Designers are extra careful about shear, especially in beams and consequently higher safety factors are used in shear design. Several equations are available in literature to determine the shear capacity of beams, i.e. ACI equation, Zsutty equation and KIM & White equation. To verify the application of ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Structural and Construction Engineering (Transactions of AIJ)
سال: 2010
ISSN: 1881-8153,1340-4202
DOI: 10.3130/aijs.75.1867