Residual Current Measurement using Helmholtz Coil Configuration with different Current Flow

Design Modification of Rogowski Coil for Current Measurement in Low Frequency

The principle object of this paper is to offer a modified design of Rogowski coil based on its frequency response. The improvement of the integrator circuit for nullifying the phase difference between the waveforms of the measured-current and the corresponding terminal voltage is a further object of this investigation. This paper addresses an accurate, yet more efficient measuring and protect...

Mitigation Transformer Inrush Current Using Modified Transient Current Limiter

This study presents a modified transient current limiter (MTCL) for mitigation the inrush current of transformers. The MTCL is based on conventional transient current limiter (TCL), which, its configuration is modified to overcome the TCL drawbacks of operation. The proposed MTCL offers lower power losses and voltage/current THD during normal operation mode. It needs only one limiting reactor i...

Minimax Current Density Coil Design

Introduction Gradient and shim coils are required to generate a magnetic field of particular spatial form when energised with electric current. The design of these coils is a well studied inverse problem [1] that is inherently ill-conditioned with an infinite number of solutions. In order to obtain a single solution, the system must be regularised, which is commonly achieved by minimising the s...

Torque Control of Brushless Direct Current Motor Drives Using Single Current Sensor with High Reliability

Due to the simple structure, high torque density, low maintenance, and high efficiency, brushless direct current (BLDC) motors are widely used in automation and industrial applications. A control strategy based on single current sensor is proposed for a four-switch three-phase BLDC motor system to lower cost and improve reliability. The whole working process of the BLDC motor is divided into si...

Current Measurement