Residual flux impact in controlled switching of HVDC converter transformer

نویسندگان

چکیده

Abstract Converter transformers are an interface point of HVDC frameworks and basic hardware from activity reliability view point. turned off intentionally under planned support un-deliberately during fault conditions. Random energization transformer delivers high inrush currents due to core saturation asymmetries endanger equipment health. In this paper, charging approach has been proposed. By utilizing on wave exchanging for moderation drifters 888 MVA 400/325 kV Transformer ±800 Sub-station. The proposed procedure applied HVAC electrical Circuit Breaker furnished with Pre-Insertion Resistor considering diverse degree residual flux. Performance philosophy affirmed by field tests reproduction in PSCAD programming package is found very viable. Near investigation done paper shows that the use system, switching transient stimulation coupled three phase converter decreased worthy level.

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Transient Transformer Inrush Currents due to Closing Time- and Residual Flux Measurement- Deviations if Controlled Switching is used

During energisation of power transformers, transient inrush currents with peaks up to the short-circuit current may arise. Using controlled switching taking into account the residual flux, the transients can – in theory – be eliminated completely. Real factors such as closing time scatter and residual flux measurement uncertainty have to be considered when checking the suitability of controlled...

متن کامل

Transformer inrush current mitigation using controlled switching and magnetic flux shunts

The inrush current is a transient current that results from a sudden change in the exciting voltage across a transformer’s windings. It may cause inadvertent operation of the protective relay system and necessitate strengthening of the transformer’s mechanical structure. Many methods were reported in the literatures for reduction and mitigation of transformer inrush currents. This paper represe...

متن کامل

Determination of Acceptable Closing Time Scatter and Residual Flux Measurement Uncertainty for Controlled Switching of Transformers

Theoretically, controlled switching taking into account the residual flux is able to fully eliminate inrush currents. Due to non-idealities in the field (closing time scatter, residual flux measurement uncertainty) that significantly affect the performance of controlled switching, inrush currents of 1.0 pu must be tolerated. To calculate the maximum acceptable tolerances of both nonidealities i...

متن کامل

Controlled Single Switch Step down AC/DC Converter without Transformer

This paper presents a transformer less ac/dc converter which can be used in voltages between 90230 Vrms. Instead of a transformer, this topology consists of a buck dc/dc converter and a buck boost dc/dc converter. By the absence of transformer, reduce the complexity of converter and it is cost effective. Buck dc/dc converter keeps o/p voltage below the line voltage; limit the leakage current. B...

متن کامل

A Method for Calculation of the Inrush Current in Single Phase Transformer including the Residual Flux

A field-circuit method for simulation of transients in a single-phase, two-winding transformer has been given. The magnetic field excited by the winding currents has been analyzed, and integral parameters have been determined. Including the equivalent circuit parameters and the magnetic residual flux in the silicon steel core, the developed method has been implemented for the transitional state...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: International Journal of Emerging Electric Power Systems

سال: 2021

ISSN: ['2194-5756', '1553-779X']

DOI: https://doi.org/10.1515/ijeeps-2020-0243