Residual stress determination in thick welded steel plates
نویسندگان
چکیده
منابع مشابه
Residual stress evaluation in butt-welded steel plates
Faculty of Mechanical Engineering, Sardar Raja College of Engineering, Alangulam, Tirunelveli 627 808, India Faculty of Mechanical Engineering, Government College of Engineering, Tirunelveli 627 007, India Faculty of Mechanical Engineering, Alagappa Chettiar College of Engineering and Technology, Karaikudi 630 002, India Structural Analysis and Testing Group, Vikram Sarabhai Space Centre, Triva...
متن کاملResidual Stress Analysis and Fatigue Assessment of Welded Steel Structures
.............................................................................................................................. .i APPENDED PAPERS ............................................................................................................... ii PAPERS NOT INCLUDED IN THIS THESIS........................................................................ iii DIVISION OF WORK BETWEEN ...
متن کاملResidual stress analysis in thick uranium films
Residual stress analysis was performed on thick, 1–25 lm, depleted uranium (DU) films deposited on an Al substrate by magnetron sputtering. Two distinct characterization techniques were used to measure substrate curvature before and after deposition. Stress evaluation was performed using the Benabdi/Roche equation, which is based on beam theory of a bi-layer material. The residual stress evolut...
متن کاملThe Inherent Strain Method for Residual Stress Determination and Its Application to a Long Welded Joint
In this paper, we investigate a relatively new method for determining three-dimensional sub-surface residual stress (Ueda, 1975). This hybrid experimental/analytical method determines the source of residual stress by sectioning and strain measurement, and then uses it to deduce residual stress in the original body. When certain assumptions about the spatial distribution of the source of residua...
متن کاملInvestigation of Important Parameters in Residual Stress Determination in Isotropic Plates and Laminated Composites by Slitting Method
In the slitting method, a small width slit is created incrementally through the thickness of the stressed specimen and the released strains in each increment are recorded by a strain gauge. Compliance coefficients relate the measured strains to the residual stresses. This paper investigates the important parameters influencing the calculation of compliance coefficients for isotropic plates and ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Physics: Conference Series
سال: 2012
ISSN: 1742-6588,1742-6596
DOI: 10.1088/1742-6596/340/1/012025