Residual Stress in Multi-Indented Surface Layer of Ceramics. Effects of Hardness and X-Ray Penetration Depth on Residual Stress.
نویسندگان
چکیده
منابع مشابه
Processing Effects on Residual Stress
The goal of this paper is to address three key questions. First, what are residual stresses? Second, what causes them? And third, are they good or bad in terms of performance of springs? The first question will be addressed by beginning with some rudimentary definitions and discussion. The second will be addressed with a process-by-process evaluation of spring manufacturing. Each process will b...
متن کاملDepth-resolved residual stress evaluation from X-ray diffraction measurement data using the approximate inverse method
The paper deals with the depth determination of residual stress states from diffraction data. First an historical overview of the known approaches is given. Then we apply the approximate inverse method to this problem. This method is known to be very efficient and stable with respect to noise-contaminated data. It is even possible to prove convergence and it allows an error estimate of the calc...
متن کاملRelationship between Coverage and Surface Residual Stress
Controlled, uniform, peening has been used to impose precise cov onto mild steel plate specimens. This was achieved by using an the specimens under a single, precision-loaded, 2mm diameter studies have revealed a surprising relationship between percent surface residual stress. Stress increases almost linearly with low coverages but reaches a maximum at about 80% coverage. At 100% coverage the i...
متن کاملDetermination of Residual Stress of PACVD Nanostructure TiN Coatings by GIXRD Method
In this study, thin layers of titanium nitride (TiN) were deposited on H13 steel substrates at different duty cycles and temperature of 520 ˚C using plasma assisted chemical vapor deposition (PACVD). Uniaxial residual stress was calculated by X-ray diffraction (XRD) and Sin2 Ψ method. Then the residual stress of the samples were measured by Grazing Incidence X-ray Diffraction (GIXRD) method and...
متن کاملResidual stress in ceramics with large thermal expansion anisotropy
Residual stress was measured in sintered and heat-treated Fe2TiO5 samples with various grain sizes. The influence of texturing was assessed by comparing the residual stress states of samples having randomly oriented grains and highly oriented grains produced through magnetically assisted processing. The residual stress was measured with x-ray diffraction using Cr Ka radiation. Due to the signif...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Society of Materials Science, Japan
سال: 1994
ISSN: 1880-7488,0514-5163
DOI: 10.2472/jsms.43.772