Residual stress measurements using neutron diffraction
نویسندگان
چکیده
منابع مشابه
Residual Stress Measurements of Cast Aluminum Engine Blocks Using Diffraction
Residual stresses and strains in as-cast and annealed aluminum engine blocks were mapped in the main web area above the bearing split using diffraction. Automated coordinate-mapping of the surface and bulk strains was accomplished with X-ray and neutron diffraction, respectively. LabVIEW-based software was developed for improved efficiency, flexibility and quality of data analysis. In the hoop ...
متن کاملResidual stress measurements via neutron diffraction of additive manufactured stainless steel 17-4 PH
Neutron diffraction was employed to measure internal residual stresses at various locations along stainless steel (SS) 17-4 PH specimens additively manufactured via laser-powder bed fusion (L-PBF). Of these specimens, two were rods (diameter=8 mm, length=80 mm) built vertically upward and one a parallelepiped (8×80×9 mm3) built with its longest edge parallel to ground. One rod and the parallele...
متن کاملResidual Stress Measurement of Laser-Engineered Net Shaping AISI 410 Thin Plates Using Neutron Diffraction
In an attempt to relate the laser-engineered net shaping (LENS) process parameters, laser power and laser travel speed, to the quality of LENS-produced parts, strain measurements were taken at several predetermined points within seven LENS AISI 410 thin plates using the neutron diffraction method. The residual stresses at these points were then calculated using the measured strain values to asc...
متن کاملNeutron diffraction residual strain measurements in nanostructured hydroxyapatite coatings for orthopaedic implants.
The failure of an orthopaedic implant can be initiated by residual strain inherent to the hydroxyapatite coating (HAC). Knowledge of the through-thickness residual strain profile in the thermally sprayed hydroxyapatite coating/substrate system is therefore important in the development of a new generation of orthopaedic implants. As the coating microstructure is complex, non-destructive characte...
متن کاملResidual-strain Determination by Least-squares Refinement of Tof Neutron-diffraction Measurements of Deformed Uranium
We report the complete macroscopic average strain tensor for a cold-rolled uranium plate. The strain tensor was determined by the least-squares refinement of interplanar spacings for 19 Bragg reflections, as determined from the neutron TOF measurements at LANSCE. An annealed uranium plate was used as a reference sample, thus providing reference interplanar spacings for all 19 reflections. We al...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Welding and Joining
سال: 2015
ISSN: 2466-2232
DOI: 10.5781/jwj.2015.33.1.30