Reversed Creep Deformation Behavior of Metals
نویسندگان
چکیده
منابع مشابه
Finite element modeling of creep deformation in cellular metals
The creep of reticulated metallic foams is studied through the finite element method using three-dimensional, periodic unit cells with four different architectures characterized by struts which deform primarily by: (i) simple bending, (ii) compression, (iii) a combination of simple bending and compression and (iv) double bending (for Kelvin space-filling tetrakaidecahedra). The creep behavior o...
متن کاملCreep Deformation of Ice
Knowledge of the creep properties of ice often is needed in field and theoretical studies of the flow and deformation of glaciers, ice shelves, and ice sheets. Recently many of the icy moons in the solar system have become much better known as a result of the successful deep-space probe missions. An understanding of the physical processes that take place within them requires information about t...
متن کاملThe Cyclic Deformation Behavior of Severe Plastic Deformation (SPD) Metals and the Influential Factors
A deeper understanding of the mechanical behavior of ultra-fine (UF) and nanocrystalline (NC) grained metals is necessary with the growing interest in using UF and NC grained metals for structural applications. The cyclic deformation response and behavior of UF and NC grained metals is one aspect that has been gaining momentum as a major research topic for the past ten years. Severe Plastic Def...
متن کاملSevere Plastic Deformation of Metals
This paper provides an introduction in the field of severe plastic deformation (SPD). First of all the main methods to produce SPD materials are discussed. In the following section, the mechanisms leading to the formation of fine grains are reviewed and the influence of changes in strain path is highlighted. During post-SPD thermal annealing, some typical microstructural changes take place. The...
متن کاملFluctuations and scaling in creep deformation.
The spatial fluctuations of deformation are studied in the creep in Andrade's power law and the logarithmic phases, using paper samples. Measurements by the digital image correlation technique show that the relative strength of the strain rate fluctuations increases with time, in both creep regimes. In the Andrade creep phase characterized by a power-law decay of the strain rate ϵt∼t(-θ), with ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Society of Materials Science, Japan
سال: 1972
ISSN: 1880-7488,0514-5163
DOI: 10.2472/jsms.21.179