Rib waveguide as a three-mode demultiplexer for SOI
نویسندگان
چکیده
منابع مشابه
Single-transverse-mode Ti:sapphire rib waveguide laser.
Laser operation of Ti:sapphire rib waveguides fabricated using photolithography and ion beam etching in pulsed laser deposited layers is reported. Polarized laser emission was observed at 792.5 nm with an absorbed pump power threshold of 265 mW, which is more than a factor of 2 lower in comparison to their planar counterparts. Measured beam propagation factors M2x and M2y of 1.3 and 1.2, respec...
متن کاملS-Bend Silicon-On-Insulator (SOI) Large Cross-Section Rib Waveguide for Directional Coupler
Received Oct 19, 2016 Revised Jan 4, 2017 Accepted Feb 1, 2017 S-bend contributes the high losses in the silicon-on-insulator (SOI) large cross-section rib waveguide (LCRW). The objective of this work is to investigate S-bend SOI LCRW with two different single-mode dimensions named symmetrical and asymmetrical. The S-bend SOI LCRW has been simulating using beam propagation method in OptiBPM sof...
متن کاملAn all-silicon, single-mode Bragg cladding rib waveguide.
In this paper, we demonstrate a direct method of fabricating an all-silicon, single-mode Bragg cladding rib waveguide using proton beam irradiation and subsequent electrochemical etching. The Bragg waveguide consists of porous silicon layers with a low index core of 1.4 that is bounded by eight bilayers of alternating high and low refractive index of 1.4 and 2.4. Here, the ion irradiation acts ...
متن کاملWaveguide-Mode Sensors as Aptasensors
Aptamers are artificial nucleic acid ligands that can be generated by in vitro selection through partition and amplification. Aptamers can be generated against a wide range of biomolecules through the formation of versatile stem-loop structures. Because aptamers are potential substitutes for antibodies and drugs, the development of an aptamer-based sensor (aptasensor) is mandatory for diagnosis...
متن کاملA single-lithography SOI rib waveguide sensing circuit with apodized low back-reflection surface grating fiber coupling
We present a single-lithography Mach-Zehnder interferometer sensor circuit, with integrated low back-reflection input and output grating couplers. The low back-reflection is accomplished by a duty cycle apodization optimized for coupling light between single-mode silica fibers and the nanometric silicon-on-insulator (SOI) rib-waveguides. We discuss the design, fabrication, and characterization ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: OSA Continuum
سال: 2018
ISSN: 2578-7519
DOI: 10.1364/osac.2.000124