Rolling induced size effects in elastic–viscoplastic sheet metals
نویسندگان
چکیده
منابع مشابه
Rolling induced Size effects in Elastic-viscoplastic Sheet Metals
Rolling processes for which the characteristic length scale reaches into the range where size effects become important are receiving increased interest. In particularly, this is owed to the roll-molding process under development for high-throughput of micronscale surface features. The study presented revolves around the rolling induced effect of visco-plasticity (ranging hot and cold rolling) i...
متن کاملAsymptotic analysis of asymmetric thin sheet rolling
An analytical model for asymmetric rolling is presented, which includes asymmetry in roll friction, roll size and roll speed, for a rigid, perfectly plastic thin sheet deformed with Coulomb friction. This model is solved asymptotically, based on the systematic assumptions that both the roll gap aspect ratio and the friction coefficient are small. While the leading order solution is shown to be ...
متن کاملAn Upper Bound Analysis of Sandwich Sheet Rolling Process
In this research, flat rolling process of bonded sandwich sheets is investigated by the method of upper bound. A kinematically admissible velocity field is developed for a single layer sheet and is extended into the rolling of the symmetrical sandwich sheets. The internal, shear and frictional power terms are derived and they are used in the upper bound model. Through the analysis, the rolling ...
متن کاملCorrosion Properties of Structured Sheet Metals in Salt Environment
In the present paper the corrosion properties of structured sheet metals were investigated. The aim of this work is to determinate the influence of the structuring process on the corrosion resistance of sheet metals. For this purpose, these sheets were examined by accelerated tests in corrosion chamber. The investigation was carried out using salt spray test. The experiment was conducted for th...
متن کاملSimulation of Kinetic Friction in L-Bending of Sheet Metals
This paper aims at experimental and numerical investigation of springback behavior of sheet metals during Lbending process with emphasis on Stribeck-type friction modeling. The coefficient of friction in Stribeck curve depends on sliding velocity and contact pressure. The springback behavior of mild steel and aluminum alloy 6022-T4 sheets was studied experimentally and using numerical simulatio...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: European Journal of Mechanics - A/Solids
سال: 2015
ISSN: 0997-7538
DOI: 10.1016/j.euromechsol.2015.05.006