Rolling Texture of Al-Mg Alloys

The Texture Behavior of Al-Mg-Sc Alloys

Three alloys of Al-Mg with and without scandium are cold worked at different percentage and then annealed. The texture behavior of the alloys is studied by X-ray diffraction technique. The X-ray diffraction analysis is done using a PHILIPS PW1830 diffractometer with Cu-Kα radiation. It is found that the addition of scandium in Al-6Mg alloy influences the development of texture. The cube texture...

Precipitation Hardening of Al–Si–Mg Alloys

EXPERIMENTALl ANALYSIS OF PARTITION COEFFICIENT IN Al-Mg ALLOYS

Because the partition coefficient is one of the most important parameters affecting microsegregation, the aim of this research is to experimentally analyse the partition coefficient in Al-Mg alloys. In order to experimentally measure the partition coefficient, a series of quenching experiments during solidification were carried out. For this purpose binary Al-Mg alloys containing 6.7 and 10.2 w...

Melt Protection of Mg-Al Based Alloys

This paper reports the current status of Mg melt protection in view to identify near-future challenges, but also opportunities, for Mg melt protection of Mg-Al based alloys. The goal is to design and manufacture sustainable Mg alloys for resource efficiency, recycling and minimising waste. Among alternative cover gas technologies for Mg melt protection other than SF6: commercially available tec...

Influence of thermomechanical processing on the grain size, texture and mechanical properties of Mg-Al alloys

The work carried out by the authors over the last decade on the processing, microstructural characterization and the mechanical behaviour of Mg alloys is reviewed. In particular, the potential for grain refinement and for the development of specific textures of large strain hot rolling (LSHR), equal channel angular pressing (ECAP) and accumulative roll bonding (ARB) is discussed. The recrystall...