Rotary compression in tool cavity—a new ductile fracture calibration test
نویسندگان
چکیده
منابع مشابه
Numerical modelling of ductile fracture in blanking
• A submitted manuscript is the author's version of the article upon submission and before peer-review. There can be important differences between the submitted version and the official published version of record. People interested in the research are advised to contact the author for the final version of the publication, or visit the DOI to the publisher's website. • The final author version ...
متن کاملEngineering ductile fracture in brittle-matrix composites
This letter describes a newly discovered phenomenon: ductile fracture in cementitious materials. The brittle nature of materials such as concrete and ceramics has prompted the development of various approaches to enhance their fracture toughness. Fibre reinforcement has been the common focus in the toughening of the brittle materials. Two types of fracture have been observed to date in cementit...
متن کاملEVALUATING HOT DEFORMATION BEHAVIOR OF W360 TOOL STEEL BY HOT COMPRESSION TEST
In this research, the hot deformation behavior of W360 tool steel was investigated using hot compression test at 1000-1200°C and strain rates of 0.001, 0.01, 0.1, and 1 s-1. According to the results, dynamic recrystallization was found the most important restoration factor of this alloy during hot deformation. Recrystallization was enhanced with an increase in temperature and strain rate. Also,...
متن کاملA Simple Method to Determine Ductile Fracture Strain in a Tensile Test of Plane Specimen’s
In several practical cases, the ultimate ductile fracture strain determined with tensile test is accepted as a material plasticity measure 1 . In this case, the plasticity has to be defined as an ability of a material to accommodate high permanent strains until fracture appears where this strain reaches certain value called ultimate fracture strain p. The strain value until fracture depends not...
متن کاملA New Test Compression Scheme
Generalized Modified Positional Syndrome (GMPS), of order p, a new compaction scheme for test output data is presented. The order p determines the alising probability and the amount of hardware overhead required to implement the scheme. GMPS of order two gives an aliasing probability about an order of magnitude lower than the best scheme reported in literature with minimal extra hardware. A har...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: The International Journal of Advanced Manufacturing Technology
سال: 2020
ISSN: 0268-3768,1433-3015
DOI: 10.1007/s00170-020-04943-5