Rotor blades blockage modulation suppression algorithm for helicopter‐borne SAR
نویسندگان
چکیده
منابع مشابه
Ultrasonic Shear Wave Anti-Icing System for Helicopter Rotor Blades
A new conceptual non-thermal anti-icing system for helicopter rotor blades is introduced. Theoretical calculations predict that certain ultrasonic modes generated by horizontal shear waves produce sufficient interface stresses between a host structure and ice to remove the accreted ice layer. Experimentally obtained ultrasonic shear dispersion curves are compared to theoretical predictions for ...
متن کاملAcoustics of Uh-60 Black Hawk with Growth Rotor Blades
Acoustic data were acquired during a flight test in 1995 of a UH-60L Black Hawk equipped with Growth Rotor Blades (GRB) performing terminal area operations. Limited acoustic data from the same aircraft equipped with Standard Rotor Blades (SRB) were also acquired. These data were analyzed and compared with data from a 1993 flight test of a UH-60A aircraft to assess differences in acoustics chara...
متن کاملReduced Rank Interference Suppression for Multichannel SAR
Large regions of a Synthetic Aperture Radar (SAR) image can potentially be destroyed by an airborne broadband jammer. Jammer components include both the direct-path and multipath reflections from the ground, known as hot-clutter (HC) or terrain scattered interference. Using multiple antennas on a SAR provides spatial degrees of freedom and allows for beamforming to reject the direct-path signal...
متن کاملSpeckle Suppression Method for SAR Image
In this study, a new speckle reduction method was proposed in terms of by Bidimensional Empirical Mode Decomposition (BEMD). In this method, the SAR image containing speckle noise was decomposed into a number of elementary components by using BEMD and then the extremal points are done the boundary equivalent extension after screening and the residual continue to be done the boundary equivalent ...
متن کاملTool Path Generation and Manufacturing Process for Blades of a Compressor Rotor
This paper presents a complete procedure for tool path planning and blade machining in 5-axis manufacturing. The actual cutting contact and cutter locations can be determined by lead and tilt angles. The tool path generation is implemented by piecewise curved approximation and chordal deviation detection. An application about drive surface method promotes flexibility of tool control and stabili...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IET Signal Processing
سال: 2021
ISSN: 1751-9675,1751-9683
DOI: 10.1049/sil2.12032