RS-485 Interface for Boiler Header Inspection Robot Prototype
نویسندگان
چکیده
منابع مشابه
EMAT Integrated with Vertical Climbing Robot for Boiler Tube Inspection
National Thermal Power Corporation (NTPC) has signed an MoU with Bhabha Atomic Research Centre (BARC) for design and development of automated boiler tube inspection system for vertical water wall tubes. A vertical climbing robot has been developed for this purpose at Division of Remote Handling & Robotics (DRHR), BARC. Recently, an Electromagnetic Acoustic Transducer (EMAT) has been integrated ...
متن کاملA Prototype Climbing Robot for Inspection of Complex Ferrous Structures
This is where the abstract should be placed. It should consist of one paragraph giving a concise summary of the material in the article below. Replace the title, authors, and addresses with your own title, authors, and addresses. You may have as many authors and addresses as you like. It is preferable not to use footnotes in the abstract or the title; the acknowledgments of funding bodies etc. ...
متن کاملExplanation of Maxim RS-485 Features - AN367
Features are described for Maxim's large selection of RS-485 transceivers. Devices are identified to meet requirements for halfor full-duplex operation, supply voltages down to 2.5V, ESD protection up to ±15kV, data rates from 250kbps to 12Mbps, slew-rate limited devices for low radiated noise operation, fail-safe operation with open or shorted cables, normal 1 unit-load to 1/8 unit-load for ex...
متن کاملSelecting and Using RS-232, RS-422, and RS-485 Serial Data Standards - AN723
Three common serial data standards, RS-232, RS-422, and RS-485, are described by specification and electrical interface. Cable termination techniques, use of multiple loads, daisy-chaining of RS-232, conversion of RS-232 to RS-485, conversion of RS-485 to RS-232, and RS-232 port-powered RS-485 conversions are described.
متن کاملVehicle Suspension Inspection by Stewart Robot
The suspension system of a vehicle is one of the most important parts which is involved in the process of vehicle designing. When a vehicle suspension system is designed, the evaluation of its performance against the road disturbances such as shocks and bumps are very important. The most commonly used systems consist of four hydraulic Jacks with mobility in vertical line with low speed and l...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Procedia Engineering
سال: 2012
ISSN: 1877-7058
DOI: 10.1016/j.proeng.2012.07.340