Satellite signal detection method based on modification compression operator
نویسندگان
چکیده
منابع مشابه
Fast GNSS satellite signal acquisition method based on multiple resamplings
A fast Global Navigation Satellite System (GNSS) satellite signal acquisition method based on resampling is presented. In contrast to traditional approaches, which perform a single-round search with a high data rate, the proposed method introduces a signal acquisition mechanism that uses data resampling. Starting from a resampled data rate slightly above the Nyquist frequency, the proposed meth...
متن کاملImage Compression Method Based on QR-Wavelet Transformation
In this paper, a procedure is reported that discuss how linear algebra can be used in image compression. The basic idea is that each image can be represented as a matrix. We apply linear algebra (QR factorization and wavelet transformation algorithms) on this matrix and get a reduced matrix out such that the image corresponding to this reduced matrix requires much less storage space than th...
متن کاملCross B - energy operator - based signal detection a )
In this paper, two methods for signal detection and time-delay estimation based on the cross B-energy operator are proposed. These methods are well suited for mono-component AM-FM signals. The B energy operator measures how much one signal is present in another one. The peak of the B operator corresponds to the maximum of interaction between the two signals. Compared to the cross-correlation fu...
متن کاملSmall Satellite Cloud Detection Based On Deep Learning and Image Compression
An effective on-board cloud detection method in small satellites would greatly improve the downlink data transmission efficiency and reduce the memory cost. In this paper, an ensemble method combining a lightweight U-Net with wavelet image compression is proposed and evaluated. The red, green, blue and infrared waveband images from Landsat-8 dataset are trained and tested to estimate the perfor...
متن کاملFault Detection Method on a Compressor Rotor Using the Phase Variation of the Vibration Signal
The aim of this work is the application of the phase variation in vibration signal for fault detection on rotating machines. The vibration signal from the machine is modulated in amplitude and phase around a carrier frequency. The modulating signal in phase is determined after the Hilbert transform and is used, with the Fast Fourier Transform, to extract the harmonics spectrum in phase. This me...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Electronics and Control Systems
سال: 2013
ISSN: 1990-5548
DOI: 10.18372/1990-5548.37.6327