Scan Shift Time Reduction Using Test Compaction for On-Chip Delay Measurement
نویسندگان
چکیده
منابع مشابه
Design of Signature Registers Using Scan Flip-flops for On-chip Delay Measurement
This paper presents a delay measurement techniques using signature analysis, and a scan design for the proposed delay measurement technique to detect small-delay defects. The proposed measurement technique measures the delay of the explicitly sensitized paths with the resolution of the on-chip variable clock generator. The proposed scan design realizes complete on-chip delay measurement in shor...
متن کاملSwitching Activity Reduction Using Scan Shift Operation
This paper presents BIST TPG (built in self test) for low power dissipation and high fault coverage a low hardware overhead test pattern generator (TPG) for scan-based built-in self-test (BIST) that can reduce switching activity in circuits under test (CUTs) during BIST and also achieve very high fault coverage with reasonable lengths of test sequences. The proposed BIST TPG subside transitions...
متن کاملOptimization of Scan Time of Scan Test in System-on-chip
We present an SoC testing approach that integrates test data compression, T AM/test wrapper design, and test scheduling. An improved LFSR reseeding technique is used as the compression engine. All cores on the SoC share a single on-chip LFSR. At any clock cycle, one or more cores can simultaneously receive data from the LFSR. Seeds for the LFSR are computed from the care bits from the test cube...
متن کاملTest application time reduction for scan based sequential circuits
This paper addresses the issue of reducing test application time in sequential circuits with partial scan using a single clock configuration without freezing the state of the non-scan flip-flops. Experimental results show that this technique significantly reduces test application time. Further, we study the effect of ordering the scan flip-flops on the test vector length and also present a non-...
متن کاملStatic Test Compaction for Multiple Full-Scan Circuits
Current design methodologies and methodologies for reducing test data volume and test application time for full-scan circuits allow testing of multiple circuits (or subcircuits of the same circuit) simultaneously using the same test data. We describe a static compaction procedure that accepts test sets generated independently for multiple full-scan circuits, and produces a compact test set that...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IEICE Transactions on Information and Systems
سال: 2014
ISSN: 0916-8532,1745-1361
DOI: 10.1587/transinf.e97.d.533