Screen-Printed Interdigital Structure on Flexible RTM6 Substrate
نویسندگان
چکیده
منابع مشابه
Screen-printed flexible MRI receive coils
Magnetic resonance imaging is an inherently signal-to-noise-starved technique that limits the spatial resolution, diagnostic image quality and results in typically long acquisition times that are prone to motion artefacts. This limitation is exacerbated when receive coils have poor fit due to lack of flexibility or need for padding for patient comfort. Here, we report a new approach that uses p...
متن کاملDiode-switched thermal-transfer printed antenna on flexible substrate
We demonstrate that diode-switching can be used to introduce frequency agility into antennas produced by thermal transfer printing. Our particular example is a triangular Sierpinski fractal pattern with two PIN diodes to switch between operation optimised for the 800 MHz UHF band (diodes on) and the 2400 MHz ISM band (diodes off). Our measured results show an improvement in S11 in the UHF band ...
متن کاملScreen printed passive components for flexible power electronics
Additive and low-temperature printing processes enable the integration of diverse electronic devices, both power-supplying and power-consuming, on flexible substrates at low cost. Production of a complete electronic system from these devices, however, often requires power electronics to convert between the various operating voltages of the devices. Passive components-inductors, capacitors, and ...
متن کاملFlexible transistor active matrix array with all screen-printed electrodes
Flexible transistor active matrix array is fabricated on PEN substrate using all screen-printed gate, source and drain electrodes. Parylene-C and DNTT act as gate dielectric layer and semiconductor, respectively. The transistor possesses high mobility (0.33 cm 2 V -1 s -1 ), large on/off ratio (> 10 6 ) and low leakage current (~10 pA). Active matrix array consists of 10×10 transistors were dem...
متن کاملScreen printed flexible Bi2Te3-Sb2Te3 based thermoelectric generator
This paper reports the fabrication and testing of Bismuth Tellurium (Bi2Te3) – Antimony Tellurium (Sb2Te3) based thermocouples using screen printing technology. In this study, screen printable thermoelectric pastes were developed and the transport properties of cured material were measured. The dimension of each planer thermoleg is 39.3 mm × 3 mm with a thickness of 67 μm for Bi2Te3 leg and 62 ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Proceedings
سال: 2017
ISSN: 2504-3900
DOI: 10.3390/proceedings1040612