Second-order Effect Finite Element Analysis of Stainless Steel Frame Structure
نویسندگان
چکیده
منابع مشابه
Comparison of slot deformation in stainless steel and ceramic brackets during torque - A finite element analysis
Introduction: Torque in orthodontics is vital in final positioning of the teeth during fixed appliance therapy. Torqueing of archwires is a significant factor in transferring the applied forces to the bracket which might cause deformation of the slot. Any deformation in the bracket slot can vary the torque prescription and thus can affect the tooth position. Aim: To evaluate and compare the def...
متن کاملFinite Element Analysis of Hardened Steel Cutting
Hard machining, as attractive replacement for many rough and finish grinding operation, generates high cutting forces and temperature that enhance tool wear when act together. Therefore, the tool geometry and machining parameters have to be carefully optimized for a given material. Because of high cost and time consuming experimental work up-to-date advanced software for modeling and simulation...
متن کاملB-Spline Finite Element Method for Solving Linear System of Second-Order Boundary Value Problems
In this paper, we solve a linear system of second-order boundary value problems by using the quadratic B-spline nite el- ement method (FEM). The performance of the method is tested on one model problem. Comparisons are made with both the analyti- cal solution and some recent results.The obtained numerical results show that the method is ecient.
متن کاملSecond order Sigma-Delta (Σ∆) quantization of finite frame expansions ⋆
The second order Sigma-Delta (Σ∆) scheme with linear quantization rule is analyzed for quantizing finite unit-norm tight frame expansions for Rd. Approximation error estimates are derived, and it is shown that for certain choices of frames the quantization error is of order 1/N2, where N is the frame size. However, in contrast to the setting of bandlimited functions there are many situations wh...
متن کاملExperimental and 3D Finite Element Studies of CW Laser Forming of Thin Stainless Steel Sheets
Laser forming as a springback-free and noncontact forming technique has been under active investigation over the last decade. Previous investigations are mainly focused on forming of large and thick workpieces using high power lasers, with less work on precision, micro-scale bending of small and thin sheets. In this work, a 4 W continuous wave argon ion laser is used as the energy source, and t...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IOP Conference Series: Earth and Environmental Science
سال: 2019
ISSN: 1755-1315
DOI: 10.1088/1755-1315/267/3/032073